Abstract:The Yb:fiber based high-power and high-energy ultrafast lasers usually feature central wavelength of 1030 nm instead of the more common one of 1064 nm, thus limiting some potential wavelength-dependent applications. In this work, a hectowatt 1064-nm femtosecond chirped pulse amplification (CPA) system based on double-stage rod-type photonic crystal fiber (PCF) amplifier was demonstrated, with a pulse energy of 212-μJ and a repetition rate of 0.5 MHz. Compared with our previous work [Opt. Express 30(6), 3611, 2022], two key measures were employed. Firstly, a Yb:YAG crystal was intentionally introduced as a spectral filter for avoiding 1030-nm amplified spontaneous emission (ASE) oscillation, which hence improved the signal-to-noise ratio (SNR) by 15 dB. Secondly, an additional stage of rod-type PCF amplifier was adopted for further power scaling, achieving an average power of 127 W. Finally, the pulse was compressed to ∼460 fs, with an average power of 106 W and a compression efficiency of ∼83%. The beam quality factors (M2) were measured to be M2 X = 1.12 and M2 Y = 1.09. To the best of our knowledge, this is the highest pulse energy among 1064-nm hectowatt-level femtosecond lasers, thus providing a high-quality source for wavelength-dependent applications. For example, it can be used as a driver for high-repetition-rate vacuum ultraviolet (VUV) sources about 10.5 eV, with an expected conversion efficiency of up to 1%.

A versatile high-average-power ultrafast infrared driver tailored for high-harmonic generation and vibrational spectroscopy

High-energy, Phase-Stable, Ultrabroadband Khz OPCPA at 21 Μm Pumped by a Picosecond Cryogenic Yb:YAG Laser

CEP-Stable, Few-Cycle, kHz OPCPAs for Attosecond Science: Energy Scaling and Coherent Sub-Cycle Pulse Synthesis

Amplification Assisted Optical Parametric Oscillator in the Mid-Infrared Region

Broadband High-Power Mid-Ir Femtosecond Pulse Generation from an Ytterbium-Doped Fiber Laser Pumped Optical Parametric Amplifier

High-repetition rate optical parametric chirped pulse amplification system for attosecond science experiments

Mid-infrared pulse generation via achromatic quasi-phase-matched OPCPA

Optimization of a multi-TW few-cycle 1.7-$μ$m source based on Type-I BBO dual-chirped optical parametric amplification

Ho:YLF amplifier with Ti:Sapphire frontend for pumping mid-infrared optical parametric amplifier

75 MW few-cycle mid-infrared pulses from a collinear apodized APPLN-based OPCPA

Widely tunable, high-repetition-rate, dual signal-wave optical parametric oscillator by using two periodically poled crystals

Table-top high-energy 7 um OPCPA and 260 mJ Ho:YLF pump laser

Ultralow-Noise Optical Parametric Amplifier for Stimulated Raman Scattering Imaging

High-average-power, 2-μm femtosecond optical parametric oscillator synchronously pumped by a thin-disk, mode-locked laser.

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

A High-Power Continuous-Wave Mid-Infrared Optical Parametric Oscillator Module

Temperature- And Wavelength-Insensitive Parametric Amplification Enabled By Noncollinear Achromatic Phase-Matching

10-µJ-level femtosecond pulse generation in the erbium CPA fiber source with microstructured hollow-core fiber assisted delivery and nonlinear frequency conversion

High-energy, Few-cycle, Khz OPCPA at 2.1 Μm Pumped by a Picosecond Cryogenic Yb:YAG Laser

Optimally efficient, high power, Yb:fiber laser pumped, near- to mid-infrared picosecond optical parametric oscillator

Mid-infrared frequency domain optical parametric amplifier