Early Pulp Changes in the Teeth of a Dog Following Full Crown Preparations

S. Seltzer

DOI: https://doi.org/10.1177/00220345580370020601

1958-04-01

Abstract:INEVITABLY associated with crown preparation of a tooth are increases of pressure, temperature, and vibration. The effects of pressure on the dental pulp have not been comprehensively investigated. As an incidental finding, we have noted that human teeth which have been extracted with forceps invariably presented an area of odontoblastic destruction. This area coincided precisely with the dentinal tubules which had been exposed and crushed by the beaks of the forceps. In some cases, there was, in addition, some capillary hemorrhage between the odontoblasts. It appeared that for each tubule exposed to pressure, the corresponding odontoblast was ruptured. Others have noted and recorded these same phenomena. 2, 3 The effects of pressure and heat on the dental pulp cannot be separated since there apparently exists a direct correlation between the 2 factors. The greater the pressure of the cutting instrument, the higher the frictional heat developed.3-6 Investigators6-'2 have measured the rise in temperature within a tooth when it has been cut with stones, burs, and diamond instruments. The implications that these increases are capable of producing serious irreparable damage to the dental pulp were not borne out by the investigations of Lisanti and Zander.13 They found that temperatures of 1250 F. to 600iF. applied to the dentin of dogs' teeth for 5 seconds to 1 minute were capable of producing changes in the pulp, ranging from separation of the odontoblastic layer from the dentin to destruction of the odontoblastic layer and blister formation within the pulp. In all cases, however, healing took place as time elapsed and within 2 months there was repair with no pulp deaths. In full crown preparation, however, where all the dentinal tubules are exposed, and the total drilling time exceeds 1 minute, repair might not be so complete. When extra increments of irritation in the form of heat and pressure from modelling compound are added, the pulp reaction might not be so favorable. Lisanti and Zander13 listed many factors which may influence the amount of heat produced during operative procedures. An important method of controlling the heat produced is by the use of water coolants on the teeth while cutting is taking place.5' 6, 9 The purposes of this investigation were (1) to study the effects of crown preparation with rotary tools run at comparatively low speeds on the pulps of