Model Catalytic Studies over Metal Single Crystalst

Wayne Goodman

Abstract:Heterogeneous catalysis is of major importance to most chemical and fuel technologies. Little is known, however, about surface reactions at the molecular level because the tools for such investigations have only become recently available. During the past 2 decades, modern surface science’ has provided an array of techniques to characterize the surface region and, consequently, the ability to study molecular adsorption and reaction on a molecular level. The ordering of surface atoms in ideal cases can be ascertained with precision by using low-energy electron diffraction (LEED), and their oxidation states can be probed by using X-ray photoelectron spectroscopy (XPS). The surface composition can be determined in most cases with a sensitivity better than 1% with Auger spectroscopy (AES) and XPS. Other techniques such as ultraviolet photoelectron spectroscopy (UPS), high-resolution electron energy loss spectroscopy (HREELS), secondary ion mass spectrometry (SIMS), ion scattering spectroscopy (ISS), and molecular scattering permit study of adsorption and reaction on atomically clean surfaces. The data obtained by these sensitive techniques provide an important link to the understanding of reaction mechanisms and the relationship between the reactivity of a surface, its structure, and its composition. Most surface techniques require an ultrahigh vacuum environment and generally are best utilized in studying low-surface materials such as single crystals with areas of N 1 cm2. Correlating information between such an idealized system and high-area, supported catalysts at atmospheric conditions understandably can be criticized. Indeed, if metal single crystals are to be used as catalyst models, it is essential to demonstrate the relationship of their kinetic parameters to high-area, supported catalysts at realistic reaction conditions. The measurement of these parameters for single crystals and their relationship to working catalysts are essential features of our research program. These studies use the specialized apparatus2 shown in Figure 1. The custom-built catalytic reactor, contiguous to the surface analysis system, employs a retraction bellows that supports the metal crystal. The samples can be translated in situ from the reactor to the surface analysis chamber. Typically, the single crystals are spotwelded to short, high-purity leads and resistively heated. High-purity gases are used to mea-