Abstract:Transformer performance and efficiency can be enhanced by effectively address the properties of its insulation system. The power transformer insulation system weakens as a result of operational thermal stresses brought on by dynamic loading and shifting environmental patterns. Winding hot spot temperature is a crucial metric that must be maintained below the prescribed limit while power transformers are operating so as to maintained power system reliability. This is due to the fact that, among other variables, the time-dependent aging effect of insulation depends on transitions in hot spot temperatures. Due to the non-linear nature of the conventional mathematical models used to determine these temperatures, and complexity of thermal phenomena, investigations still need to be exercised to fully understand the variables that associate with hot spot temperature computation with minimum error. This paper explores the possibilities of enhancing top oil and hot spot temperature estimation accuracy through the use of an adaptive neuro-fuzzy inference (ANFIS) technique. The paper presents an adaptive neuro fuzzy model to approximate the hot spot temperature of a mineral oil-filled power transformer based on loading, and established top oil temperature. Initially, a sub-ANFIS top oil temperature estimation model based on loading and ambient temperature as inputs is established. Using a hybrid optimization technique, the ANFIS membership functions were fine-tuned throughout the training process to reduce the difference between the actual and anticipated outcomes. The correctness and reliability of the created adaptive neural fuzzy model have been verified using real-world field data from a 60/90MVA, 132 kV power transformers under dynamic operating regimes. The ANFIS model results were validated against field measured values and literature-based electrical-thermal analogous models, establishing a precise input-output correlation. The developed ANFIS model achieves the highest coefficient of determination for both TOT and HST (0.98 and 0.96) and the lowest mean square error (7.8 and 10.3) among the compared thermal models. Correct determination of HST can help asset managers in thermal analysis trending of the in-service transformers, helping them to make proper loading recommendations for safeguarding the asset.

Prediction model of transformer top oil temperature based on data quality enhancement

Strategy for remote condition monitoring of power transformer based on feature extraction of three-dimensional temperature field

Top-Oil Temperature Prediction of Power Transformer Based on Long Short-Term Memory Neural Network with Self-Attention Mechanism Optimized by Improved Whale Optimization Algorithm

Method of Transformer Top Oil Temperature Forecasting Based on Grey-Autoregressive Differential Moving Average Model

Fault Prediction Using a Grey-Markov Model from the Dissolved Gases Contents in Transformer Oils

A New Method for Transformer Fault Prediction Based on Multifeature Enhancement and Refined Long Short-Term Memory

A New Method to Evaluate and Predict the Load Capacity of Transformer in Energy Internet with Data Mining Algorithm

Combination Prediction Method of Power Transformers Based on Feature Gas Arrangement Diagram and Grey Model

Prediction model of measurement errors in current transformers based on deep learning

Machine Learning Model for Transformer Health Monitoring and Fault Detection

Prediction of transformer top oil temperature based on improved weighted support vector regression based on particle swarm optimization

Oil Quality Index Model Verification and Validation using Total Acid Number and Interfacial Tension Experimental Data

Enhanced Prediction of Transformers Vibrations under Complex Operating Conditions

Artificial Neural Networks Application for Top Oil Temperature and Loss of Life Prediction in Power Transformers

Transformer hot spot temperature estimation through adaptive neuro fuzzy inference system approach

Machine Learning-Based Sensor Data Modeling Methods for Power Transformer PHM

Improving IEC Thermal Model for Oil Natural Air Natural Transformers Using Optimised Parameters Based on Dynamic Simulation

Efficient Reduced-Order Algorithm for Transient Simulation of Transformer Thermal Characteristics

Prediction of dissolved gas content in transformer oil based on multi‐information fusion

Structural Optimization Model of Oil-Natural Air-Natural Transformer Radiator Based on Data-Model Hybrid-Driven

A Prediction Method for Power Transformer State Parameters Based on Grid Long Short-Term Memory Network