Abstract:Abstract This paper presents the performance analysis of the system for real-time reconstruction of the shape of the rigid medical needle used for minimally invasive surgeries. The system is based on four optical fibers glued along the needle at 90 degrees from each other to measure distributed strain along the needle from four different sides. The distributed measurement is achieved by the interrogator which detects the light scattered from each section of the fiber connected to it and calculates the strain exposed to the fiber from the spectral shift of that backscattered light. This working principle has a limitation of discriminating only a single fiber because of the overlap of backscattering light from several fibers. In order to use four sensing fibers, the Scattering-Level Multiplexing (SLMux) methodology is applied. SLMux is based on fibers with different scattering levels: standard single-mode fibers (SMF) and MgO-nanoparticles doped fibers with a 35–40 dB higher scattering power. Doped fibers are used as sensing fibers and SMFs are used to spatially separate one sensing fiber from another by selecting appropriate lengths of SMFs. The system with four fibers allows obtaining two pairs of opposite fibers used to reconstruct the needle shape along two perpendicular axes. The performance analysis is conducted by moving the needle tip from 0 to 1 cm by 0.1 cm to four main directions (corresponding to the locations of fibers) and to four intermediate directions (between neighboring fibers). The system accuracy for small bending (0.1–0.5 cm) is 90 $$\%$$ % and for large bending (0.6–1 cm) is approximately 92 $$\%$$ % .

Teicoplanin vs cephradine and metronidazole in the prophylaxis of sepsis following vascular surgery: an interim analysis of an ongoing trial.

Toward FBG-Sensorized Needle Shape Prediction in Tissue Insertions

Transmission Line Tower Grounding Performance in Non-Uniform Soil

Fiber Bragg Grating-based sensor system for sensing the shape of flexible needles

Optical Fiber-Based Needle Shape Sensing in Real Tissue: Single Core vs. Multicore Approaches

Professional Finishing of CCA Pressure-Treated Wood

Robust Three-Dimensional Shape Sensing for Flexible Endoscopic Surgery Using Multi-Core FBG Sensors

Real-Time Curvature Detection of a Flexible Needle with a Bevel Tip

Bevel-Tip Needle Deflection Modeling, Simulation, and Validation in Multi-Layer Tissues

Tissue Cutting Mechanics and Applications for Needle Core Biopsy and Guidance

Design and analysis of a fiber-optic sensing system for shape reconstruction of a minimally invasive surgical needle

Simulation-based Flexible Needle Control with Single-core FBG Feedback for Spinal Injections

A Mechanics-Based Model for Predicting Flexible Needle Bending with Large Curvature in Soft Tissue

Cutting Force Of Hollow Needle Insertion In Soft Tissue

Modeling and Simulation of Flexible Needle Insertion into Soft Tissue Using Modified Local Constraints

Contributions in Medical Needle Technologies—geometry, Mechanics, Design, and Manufacturing

Modeling cutting edge geometry for plane and curved needle tips

A method for predicting needle insertion deflection in soft tissue based on cutting force identification

Simultaneous Estimation of Shape and Force along Highly Deformable Surgical Manipulators Using Sparse FBG Measurement

A study on modeling the deflection of surgical needle during insertion into multilayer tissues

Mechanics-Based Interactive Modeling for Medical Flexible Needle Insertion in Consideration of Nonlinear Factors