Abstract:Supported lipid membranes consisting of self-assembled alkanethiol and lipid monolayers on gold substrates could be produced by three different deposition methods: the Langmuir-Blodgett (L-B) technique, the painted method, and the paint-freeze method. By using cyclic voltammetry, chronoamperometry/chronocoulometry and a.c. impedance measurements, we demonstrated that lipid membranes prepared by these three deposition methods had obvious differences in specific capacitance, resistance and thickness. The specific capacitance of lipid membranes prepared by depositing an L-B monolayer on the alkanethiol alkylated surfaces was 0.53 μF cm−2, 0.44 μFcm−2 by the painted method and 0.68 μFcm−2 by the paint-freeze method. The specific conductivity of lipid membranes prepared by the L-B method was over three times lower than that of the painted lipid membranes, while that of the paint-freeze method was the lowest. The difference among the three types of lipid membranes was ascribed to the influence of the organic solvent in lipid films and the changes in density of the films. The lipid membranes prepared by the usual painted method contained a trace amount of the organic solvent. The organic solvent existing in the hydrocarbon core of the membrane reduced the density of the membrane and increased the thickness of the membrane. The membrane prepared by depositing an L-B monolayer containing no solvent had higher density and the lowest fluidity, and the thickness of the membrane was smaller. The lipid membrane prepared by the paint-freeze method changed its structure sharply at the lower temperature. The organic solvent was frozen out of the membrane while the density of the membrane increased greatly. All these caused the membrane to exist in a “tilted” state and the thickness of this membrane was the smallest. The lipid membrane produced by the paint-freeze method was a membrane not containing organic solvent. This method was easier in manipulation and had better reproducibility than that of the usual painting method and the method of forming free-standing lipid film. The solvent-free membrane had a long lifetime and a higher mechanical stability. This model membrane would be useful in many areas of scientific research.

Sizing of phosphatidylcholine vesicles by transmission electron microscopy

Behavior of Soybean Phosphatidylcholine in Silica-Gel Liquid Chromatography

Microfluidic measurement of the size and shape of lipid-anchored proteins

Using Reflectometric Interference Spectroscopy To Real-Time Monitor Amphiphile-Induced Orientational Responses Of Liquid-Crystal-Loaded Silica Colloidal Crystal Films

Counting and Sizing of Single Vesicles/Liposomes by Electrochemical Events

Quantifying size distributions of nanolipoprotein particles with single-particle analysis and molecular dynamic simulations

A simple equation to calculate the diameters of biological vesicles

Condensation of Silica Nanoparticles on a Phospholipid Membrane

Protein sizing with Differential Dynamic Microscopy

Studies of phospholipid vesicle deposition/transformation on a polymer surface by dissipative quartz crystal microbalance and atomic force microscopy.

Human lens epithelial layer in cortical cataract.

Small-Angle Neutron Scattering Studies of Mixed Bile Salt-Lecithin Colloids

Size and Shape Determination of Proteins in Solution by a Noninvasive Depolarized Dynamic Light Scattering Instrument

Supported Phospholipid Membranes: Comparison among Different Deposition Methods for A Phospholipid Monolayer

Investigation of the shapes and sizes of soft molecular aggregates in solution via partial molar volume and dynamic light scattering measurements

Sizing individual dielectric nanoparticles with quantitative differential interference contrast microscopy

On the Formation of a Macroscopically Flat Phospholipid Membrane on a Hydrosol Substrate

Fluorescence imaging of lamellipodin-mediated biomolecular condensates on solid supported lipid bilayer membranes

Scanning Tunneling Microscopy of the Phosphatidylcholine Bilayers

Several common methods of making vesicles (except an emulsion method) capture intended lipid ratios

Adsorption and fusion of hybrid lipid/polymer vesicles onto 2D and 3D surfaces