Abstract:Tensile strength is one of the most important mechanical parameters controlling the development of cracks in soil. However, it is frequently neglected in conventional geotechnical practice, because its magnitude is small and difficult to measure relative to other soil strength parameters. In this paper, a newly designed direct tensile test apparatus was employed to measure the tensile strength of an unsaturated clayey soil. A digital image acquisition and analysis system was developed for tensile strain analysis with the help of Particle Image Velocimetry (PIV) and Digital Image Correlation (DIC) techniques. Six groups of samples were compacted at a dry density of 1.7 Mg/m(3) and different water contents (6.5%, 8.5%, 10.5%, 12.5%, 16.5% and 20.5%). Test results show that the tensile strength characteristic curve (tensile strength versus water content) of the compacted unsaturated soil exhibits mono-peak feature. When water content is relatively low, the tensile strength increases with increasing water content and reaches the maximum value at a critical water content of about 9.3%. Then, it declines with further increase in water content. The evolution of tensile strength with water content depends on both suction and microstructure. Based on plotted tensile load-displacement curves, the tensile failure process can be divided into three typical stages which are: stress increasing stage (I), failure developing stage (II) and post-failure stage (III). It is found that the overall tensile failure process presents different patterns controlled by water content. Generally, the failure developing stage (II) lasts longer and the failure ductility is more pronounced when the sample is compacted at higher water content. Using PIV and DIC techniques, the development of displacement direction and strain concentration during tension can be well captured for appreciation of the soil failure mechanism. Based on the strain concentration information, the tensile fracture location and direction can be pre-determined for soil samples.

Study on the tensile characteristics of Brazilian split in remolded loess based on resistivity and DIC techniques

Mechanical Behavior of Malan Loess under Unconfined Compression Conditions

Influence of dry-wet cycles on the strength behavior of basalt-fiber reinforced loess

Physical and Mechanical Properties and Microstructures of Slip Soil of Loess Bedrock Contact Landslide

Experimental Study on the Failure Mechanism of the Zhoujiashan Landslide under the Combined Effect of Rainfall and Earthquake in Tianshui City, Northwest China

Experimental study on shear strength of saturated remolded loess.

Three-dimensional characterization and quantitative research of Malan loess microstructure under seismic loading

An experimental investigation on undrained cyclic behaviour of a saturated intact loess

Deformation Field and Acoustic Emission Characteristics of Weakly Cemented Rock under Brazilian Splitting Test

Tensile Strength of Clayey Soil and the Strain Analysis Based on Image Processing Techniques

Experimental Study of Loess Mechanical Properties with Different Water Content

Experimental study of triaxial test of loess

Investigation on the Deformation and Failure Patterns of Loess Cut Slope Based on the Unsaturated Triaxial Test in Yan’an, China

Wetting-Induced Collapse Behavior of Unsaturated and Structural Loess under Biaxial Tests Using Distinct Element Method

Deformation, strength and water variation characteristics of unsaturated compacted loess

Mode I fracturing behavior of Malan loess and implications for the toppling failure of loess slopes

Exploration on mechanical test method of improved loess under dry-wet cycles

Study on Strength Behavior of Basalt Fiber-Reinforced Loess by Digital Image Technology (DIT) and Scanning Electron Microscope (SEM)

Microstructural evolution of loess soils from the Loess Plateau of China

Experimental study on the failure process and modes of loess spoil slope induced by rainfall and engineering disturbance