Abstract:Carboxymethyl cellulose (CMC) is one of the most useful cellulose derivatives. However, it is difficult to obtain CMC with higher degree of substitution ( DS), and CMC with lower DS often exhibits a poor solubility, in water. In order to improve the degree of substitution of carboxymethyl cellulose, acrylic amide (AAm) was grafted onto cellulose, and the. sodium carboxymethyl cellulose with AAm groups (AAm-CMC-Na) was synthesized. In the present work, a novel modified CMC hydrogel based on AAm-CMC-Na aqueous solution was obtained by using gamma irradiation under appropriate conditions. The swelling behavior, crosslinking kinetics of AAm-CMC-Na hydrogels and the effects of temperature, pH value and inorganic salt concentration on the swelling ratio of hydrogel were studied in detail. Experimental. results showed that, when the concentration of AAm-CMC-Na aqueous solutions is above 12.5%, hydrogels could be prepared by gamma irradiation. However, comparing with radiation prepared CMC-Na hydrogels, the novel AAm-CMC-Na hydrogel could be produced at lower dose and lower concentration. Degradation is the predominant reaction in gamma irradiation for these two hydrogels. The swelling ratio of AAm-CMC-Na hydrogel in water. was improved with the increase of temperature and had a maximum value in the range of pH = 6 similar to 8, moreover, the swelling ratio decreased with the increasing of inorganic salt concentration and absorbed dose. The effect of CaCl(2) solution on swelling behavior of AAm-CMC-Na hydrogel was more remarkable than that of NaCl solution. The irradiation prepared AAm-CMC-Na hydrogels showed good sensibility to temperature and pH value, which implied this novel hydrogel is expected to be a water absorption material and water preserver.

Immobilization of Saccharomyces cerevisiae on to radiation crosslinked HEMA/AAm hydrogels for production of ethyl alcohol

The use of immobilized Saccharomyces cerevisiae on radiation crosslinked acrylamide–maleic acid hydrogel carriers for production of ethyl alcohol

Immobilization of Saccharomyces cerevisiae on to acrylamide–sodium acrylate hydrogels for production of ethyl alcohol

Immobilization of Yeast Cells with Polymeric Carrier Cross-Linked Using Radiation Technique

Bioethanol production by reusable Saccharomyces cerevisiae immobilized in a macroporous monolithic hydrogel matrices

Swelling and Viscoelastic Properties of Cellulose-Based Hydrogels Prepared by Free Radical Polymerization of Dimethylaminoethyl Methacrylate in Cellulose Solution

Entrapment of Saccharomyces cerevisiae and 3T3 fibroblast cells into blue light cured hydrogels

Macroporous hydrogel prepared via aqueous polymerization induced phase separation toward in situ immobilization of yeast

Immobilization of Saccharomyces uvarum cells in porous beads of polyacrylamide gel for ethanolic fermentation

Swelling Behavior of Modified Cmc Hydrogel Prepared by Radiation Crosslinking

Water Transport in Crosslinked 2‐hydroxyethyl Methacrylate

Temperature and Ph Response, and Swelling Behavior of Porous Acrylonitrile-Acrylic Acid Copolymer Hydrogels

The Influence of the Structural Architecture on the Swelling Kinetics and the Network Behavior of Sodium-Alginate-Based Hydrogels Cross-Linked with Ionizing Radiation

Saccharomyces cerevisiae yeast immobilized on marrow stem sunflower and polyacrylamide hydrogels

Radiation Preparation and Characterization of Ph-Sensitive Hydrogel of Acrylamide/β-Cyclodextrin Copolymer

Radiation preparation and swelling behavior of sodium carboxymethyl cellulose hydrogels

Characterization of the chemical and structural modifications induced by X rays on the HEMA based polymer gel

Impact of high-energy electron irradiation on mechanical, structural and chemical properties of agarose hydrogels

Cell Immobilization Using Alginate-Based Beads as a Protective Technique against Stressful Conditions of Hydrolysates for 2G Ethanol Production