Abstract:A comprehensive numerical and experimental investigation on micrometer-sized water droplet impact dynamics and evaporation on an unheated, flat, dry surface is conducted from the standpoint of spray-cooling technology. The axisymmetric time-dependent governing equations of continuity, momentum, energy, and species are solved. Surface tension, wall adhesion effect, gravitational body force, contact line dynamics, and evaporation are accounted for in the governing equations. The explicit volume of fluid (VOF) model with dynamic meshing and variable-time stepping in serial and parallel processors is used to capture the time-dependent liquid-gas interface motion throughout the computational domain. The numerical model includes temperature- and species-dependent thermodynamic and transport properties. The contact line dynamics and the evaporation rate are predicted using Blake's and Schrage's molecular kinetic models, respectively. An extensive grid independence study was conducted. Droplet impingement and evaporation data are acquired with a standard dispensing/imaging system and high-speed photography. The numerical results are compared with measurements reported in the literature for millimeter-size droplets and with current microdroplet experiments in terms of instantaneous droplet shape and temporal spread (R/D(0) or R/R(E)), flatness ratio (H/D(0)), and height (H/H(E)) profiles, as well as temporal volume (inverted A) profile. The Weber numbers (We) for impinging droplets vary from 1.4 to 35.2 at nearly constant Ohnesorge number (Oh) of approximately 0.025-0.029. Both numerical and experimental results show that there is air bubble entrapment due to impingement. Numerical results indicate that Blake's formulation provides better results than the static (SCA) and dynamic contact angle (DCA) approach in terms of temporal evolution of R/D(0) and H/D(0) (especially at the initial stages of spreading) and equilibrium flatness ratio (H(E)/D(0)). Blake's contact line dynamics is dependent on the wetting parameter (K(W)). Both numerical and experimental results suggest that at 4.5 < We < 11.0 the short-time dynamics of microdroplet impingement corresponds to a transition regime between two different spreading regimes (i.e., for We < or = 4.5, impingement is followed by spreading, then contact line pinning and then inertial oscillations, and for We > or = 11.0, impingement is followed by spreading, then recoiling, then contact line pinning and then inertial oscillations). Droplet evaporation can be satisfactorily modeled using the Schrage model, since it predicts both well-defined transient and quasi-steady evaporation stages. The model compares well with measurements in terms of flatness ratio (H/H(E)) before depinning occurs. Toroidal vortices are formed on the droplet surface in the gaseous phase due to buoyancy-induced Rayleigh-Taylor instability that enhances convection.

Interaction of a droplet spray with a turbulent plane air jet impacting a wall: Application to the confinement of atmospheres contaminated with particles by air curtain

Effects of operating conditions on droplet deposition onto surface of atomization impinging spray

Deagglomeration of Airborne Nanoparticles in a Decelerating Supersonic Round Jet

Experimental study on microscopic characteristics of impinging spray at elevated ambient pressure conditions during development

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Simulation of high-speed droplet impact against a dry/wet rigid wall for understanding the mechanism of liquid jet cleaning

Numerical Study of Spray Micro-Droplet Impinging on Dry/wet Wall

Comparison in High-Speed Droplet Impact Between Single and Multiple Collisions Against a Wall Covered With a Liquid Film

Visual experimental study of droplet impinging on liquid film and analysis of droplet evolution characteristics

Numerical Simulation of Micron and Submicron Droplets in Jet Impinging

Numerical Simulation of Aerosol Dynamics in an Impinging Jet with Microdroplet Coalescence

Receding Dynamics of Droplet Deposition on a Smooth Surface from a Central Jet to Secondary Droplet Emission

Droplet dynamics under an impinging air jet

Micrometer-sized water droplet impingement dynamics and evaporation on a flat dry surface

Atomization and droplet dynamics of a gas-liquid two-phase jet under different mass loading ratios

Dynamic characteristics of multiple droplets impinging on the wall of a liquid droplet radiator

Droplet and particle methods to investigate turbulent particle laden jets

Behavior of Hydrophobic Micron Particles Impacting on Droplet Surface

Droplet breakup and coalescence of an internal-mixing twin-fluid spray

Jet Initiation After Drop Impact on Micropatterned Hydrophilic Surfaces