Abstract:The acid production from the oxidation of hydrogen sulfide (H2S) in sewer air results in serious corrosion of exposed concrete surfaces in sewers. Large fluctuations of gaseous H2S concentrations occur in sewers due to the diurnal profiles of sewage flow and retention times and the necessity of intermittent pumping of sewage from pressure pipes into gravity pipes. How the high concentrations of H2S due to these events may affect H2S uptake and subsequent corrosion by concrete sewers is largely unknown. This study determined the effect of short- and long-term increases in H2S levels on the sulfide uptake rate (SUR) of concrete surfaces with an active corrosion layer. The results showed that during the high load situation the SUR increased significantly but then decreased (compared to the baseline SUR) by about 7-14% and 41-50% immediately after short- and long-term H2S high-load periods, respectively. For both exposure conditions, the SUR gradually (over several hours) recovered to approximately 90% of the baseline SUR. Further tests suggest multiple factors may contribute to the observed decrease of SUR directly after the high H2S load. This includes the temporary storage of elemental sulfur in the corrosion layer and inhibition of sulfide oxidizing bacteria (SOB) due to high H2S level and temporary acid surge. Additionally, the delay of the corrosion layer to fully recover the SUR after the high H2S load suggests that there is a longer-term inhibitive effect of the high H2S levels on the activity of the SOB in the corrosion layer. Due to the observed activity reductions, concrete exposed to occasional short-term high H2S load periods had an overall lower H2S uptake compared to concrete exposed to constant H2S levels at the same average concentration. To accurately predict H2S uptake by sewer concrete and hence the likely maximum corrosion rates, a correction factor should be adopted for the H2S fluctuations when average H2S levels are used in the prediction.

Enhancing the Biological Oxidation of H2S in a Sewer Pipe with Highly Conductive Concrete and Electricity-Producing Bacteria

Experimental Study on Volatile Sulfur Compound Inhibition Using a Single-Chamber Membrane-Free Microbial Electrolysis Cell

Full-scale investigation of in-situ iron and alkalinity generation for efficient sulfide control

Elimination of Sulphur Odours at Landfills by Bioconversion and the Corona Discharge Plasma Technique

A Biological Strategy for Sulfide Control in Sewers: Removing Sulfide by Sulfur-Oxidizing Bacteria.

Impact of Fluctuations in Gaseous H2S Concentrations on Sulfide Uptake by Sewer Concrete: the Effect of High H2S Loads

Modeling Sulfide Production in Full Flow Concrete Sewers Based on the HRT Variation of Sewerage.

Wastewater-Enhanced Microbial Corrosion of Concrete Sewers.

Chemical and Biological Technologies for Hydrogen Sulfide Emission Control in Sewer Systems: A Review

Mechanistic insights into Fe3O4-mediated inhibition of H2S gas production in sludge anaerobic digestion

Efficient Electrosynthesis of HO2- from Air for Sulfide Control in Sewers

Bio-corrosion in concrete sewer systems: Mechanisms and mitigation strategies

Iron carbon particle dosing for odor control in sewers: Laboratory tests

Improvement in the microbially induced corrosion resistance of concrete sewers using electrodeposition

A novel granular sludge-based and highly corrosion-resistant bio-concrete in sewers

Study on the influence of oxygen aeration as a means of controlling sulfide accumulation of sewer system

In-situ Advanced Oxidation of Sediment Iron for Sulfide Control in Sewers

Biochemical Conversion And Fate Of Sulfur Species In Wastewater Treatment Systems

Improvement of anaerobic digestion containing sulfur with conductive materials: Focusing on recent advances and internal biological mechanisms

Influence of polymer addition on biogenic sulfuric acid attack of concrete

Hydrogen Sulfide Control in Sewer Systems: A Critical Review of Recent Progress.