Abstract:The failure of fiber-reinforced ceramic and metal matrix composites under a fixed load for extended times occurs because of strength degradation in the constituent fibers. Specifically, the ceramic fibers possess a Weibull strength distribution caused by crack-like flaws, which can grow according to a power-law growth mechanism. Failure of individual fibers causes interfacial slippage and stress redistribution to unfailed fibers, which in turn accelerates the degradation rate of the remaining fibers, and culminates in abrupt failure of the composite after sufficient damage has accumulated. This sequence of events is modeled both analytically and numerically within the Global Load Sharing (GLS) approximation previously utilized for quasi-static loading. Analytically, a general constitutive model for the relationship between the stress on the damaged fiber bundle, the strain in the unbroken fibers, and the extent of damage, is combined with a time-dependent damage evolution equation derived from the slow-crack-growth kinetics to yield an integral equation for the strain vs time at fixed applied load. The relevant gauge length for a fixed-load rupture process is found to be δ = rστ which is twice the slip length prevailing at the initial applied load σ, where τ is the interfacial sliding resistance between fiber and matrix. The underlying time scale for rupture is the time scale for a typical fiber of gauge length δ to fail under the applied load σ; this time can be quite different from that measured by stress-rupture tests on single fibers at an unrelated laboratory gauge length L0. A simple, accurate but approximate relationship between applied load, time to failure, fiber Weibull modulus, and slow crack growth exponent is presented. The numerical simulations of the same degradation process verify the general accuracy of the failure time obtained from the analytic results. The remaining tensile strength after some time at load but prior to failure is also studied, and the simulation results generally exhibited a more sudden-death failure than the analytical predictions. A specific application to the failure of a Nicalon fiber composite is presented.

Toughness of Network Materials: Structural Parameters Controlling Damage Accumulation

Fracture Behavior of Fibrous Network Materials: Crack Insensitivity and Toughening Mechanism

Microstructural Evolution and Failure in Fibrous Network Materials: Failure Mode Transition from the Competition Between Bond and Fiber

Brittle fracture in disordered materials: A spring network model

Interdependent evolution of robustness, force transmission and damage in a heterogeneous quasi-brittle granular material: from suppressed to cascading failure

A New Model For Predicting The Failure Of Ductile Material

Uniaxial Tensile Strength and Notch Insensitivity of Random Sheet Networks

A Universal Scaling Law for Intrinsic Fracture Energy of Networks

Coupled Evolution of Preferential Paths for Force and Damage in the Pre-failure Regime in Disordered and Heterogeneous, Quasi-Brittle Granular Materials

Toughening Amplification of Microcracks in Staggered Composites

Predictive Maps for Stochastic Nonaffine Stiffening and Damage in Fibrous Networks

Defect Size and Cross-Linker Properties Controlled Fracture of Biopolymer Networks

Beam network model for fracture of materials with hierarchical microstructure

A Network Mechanics Method to Study the Mechanism of the Large-Deformation Fracture of Elastomers

On the Fracture Toughness of Advanced Materials

Frictional Sliding of Microcracks under Compression

Crack-Insensitive Fracture of Elastomer-Based Soft Network Materials under Monotonic and Cyclic Loads

Influence of Complex Geometries on Damage Tolerance of Porous Carbon Fiber Network

Time-dependent failure in fiber-reinforced composites by fiber degradation

A Multiscale Nonlinear Fracture Model for Staggered Composites to Reveal the Toughening Effect of Process Zone

Experimental techniques for ductile damage characterisation