Abstract:Positron analysis can reveal the information of atomic level defect of materials like metals or polymers through the study of Doppler broaden 511keV Â¿ spectra of positron with electrons that have different momentum distributions relating with the inner defect of materials. The usually used positrons come from isotope or accelerator positron source that irradiates the materials with positrons from outside. Because of the short range of positron in matter, only the surface of millimeter depth inside metals or polymers could be analyzed. To fulfill the demand of positron analysis inside the materials, high energy X-ray is used to produce positron. Two kinds of reaction is feasible, (1) is positron decay after the (Â¿, n) reaction of high energy photon with low photoneutron threshold nuclide, like N or Fe; (2) is the pair production. We use the first reaction in this paper. The algorithm to analyze the broaden 511keV Â¿ spectra is S factor or FWHM method. Maximum likelihood expectation method is also researched to deconvolute the spectra to remove the detector response for more precise electron momentum information extraction. We setup the facility with 15MeV LINAC and HPGe detector, and then test several specimens including low carbon steel, cast iron, aluminium and copper. The experimental results of five low carbon steel specimens show appreciable correspondence between positron analysis result and tensile elongation. This indicates that the atomic level defect of low carbon steel is within the range of positron analysis. On the other hand, cast iron, aluminium and copper do not show such relation. This is perhaps due to the void in these materials is so much that positron analysis method is saturated.

Development of gamma-ray-induced positron age-momentum correlation measurement

Time Evolution of Positron Affinity Trapping at Embedded Nanoparticles by Age-Momentum Correlation

A multi-stop time-of-flight spectrometer for the measurement of positron annihilation-induced electrons in coincidence with the Doppler-shifted annihilation gamma photon

Record high counting rate of a non-beam-based positron annihilation age-momentum correlation (AMOC) spectrometer achieved by geometrical optimization of detectors

Monte Carlo analysis of the contributions of long-lived positronium to the spectra of positron-impact-induced secondary electrons measured using an annihilation-gamma-triggered time-of-flight spectrometer

Optimization Study of a New Β +-Γ Coincidence Positron Annihilation Lifetime Spectrometer Using Geant4

Development of an "$α$-ToF" detector for correlated measurement of atomic masses and decay properties

Development of a Depth of Interaction Detector for Γ-Rays

Positron analysis based on high energy X-ray source

In Situ Measurement Method of Positron Annihilation in Nuclear Astro-physical Experiments

A Flexible Positron Spectrometer for the Undergraduate Laboratory

Direct positron emission imaging: ultra-fast timing enables reconstruction-free imaging

Application of positron beams to the study of positronium-forming solids

Alpha-decay-correlated mass measurement of Ra using an α-TOF detector equipped multi-reflection time-of-flight mass spectrograph system

A SiPM-based dual and triple coincidence system for positron annihilation lifetime measurement

Super High Counting Rate of Positron Annihilation Lifetime Spectrometer Achieved Via Multiple Detectors

Irradiation-induced Vacancy and Cu Aggregations in Fe–Cu Model Alloys of Reactor Pressure Vessel Steels: State-of-the-art Positron Annihilation Spectroscopy

Development of an alpha-particle imaging detector based on a low radioactivity micro-time-projection chamber

Developing a System for Measuring Coincidence Doppler Broadening Spectrum of Positron Annihilation Radiation with Very Low Background

Symmetrical Positron Annihilation Lifetime Spectrometer and Single-Sided Measurements

Measurements of Total and Positronium Formation Cross Sections for Positron-Mg Scattering