Abstract:The nitrogen reduction reaction (NRR) for ammonia synthesis is hindered by weak N2 adsorption/activation abilities and the hydrogen evolution reaction (HER). In this study, αBi2O3 (monoclinic) and βBi2O3 (tetragonal) were first synthesized by calcination at different temperatures. Experiments and calculations revealed the effects of Bi2O3 with different crystal phases on N2 adsorption/activation abilities and HER. Then, αBi2O3-x and βBi2O3-x series catalysts with surface oxygen vacancies (OVs) and Bi0 active sites were synthesized through the partial in situ reduction method. The results demonstrate the following: (I) Tetragonal βBi2O3 can better adsorb N2 and cleave the N≡N bond, thereby obtaining a lower NRR rate-limiting energy barrier (*N≡N → *N≡N-H, 0.51 eV). Meanwhile, βBi2O3 can effectively suppress HER by limiting proton adsorption (H+ + e- → *H, 0.54 eV). Therefore, βBi2O3-x series catalysts exhibit higher NH3 yield and FE than αBi2O3-x. Meanwhile, in situ FTIR further confirms that βBi2O3 could better adsorb/activate N2, and the NRR distal mechanism occurs on the Bi2O3 surface. (II) The introduction of NaBH4 promotes the conversion of part of Bi3+ on the Bi2O3 surface into Bi0 and releases OVs. The additional active sites (OVs and Bi0) enhance the overall catalyst's adsorption/activation capacity for N2, further increasing the NH3 yield and FE. Meanwhile, semimetal Bi0 can effectively limit electron accessibility, thereby inhibiting the combination of charges and adsorbed protons, reducing the HER reaction and improving the FE of NRR. Therefore, the introduction of NaBH4 effectively improved the NH3 yield and FE of the αBi2O3-x and βBi2O3-x series catalysts. After optimization, the βBi2O3-0.6 catalyst has the best NRR performance (NH3 yield: 51.36 μg h-1 mg-1cat.; FE: 38.67%), which is superior to the majority of bismuth-based NRR catalysts. This work not only studies the effects of Bi2O3 with different crystal phases on N2 and HER reaction but also effectively regulates the active components of Bi2O3 surface, thereby realizing efficient NRR to NH3 reaction, which provide valuable insights for the rational design of Bi-based NRR electrocatalysts.

Tuning Surface Potential Polarization to Enhance N 2 Affinity for Ammonia Electrosynthesis

Modulation of surface properties on cobalt phosphide for high-performance ambient ammonia electrosynthesis

Asymmetric Empty Orbitals in ZrO2-BCN for Enhancing Electrocatalytic Hydrogenation of Nitrogen to Ammonia

Boosting Nitrogen Reduction Reaction via Electronic Coupling of Atomically Dispersed Bismuth with Titanium Nitride Nanorods

Tuning Morphology and Electronic Structure of Amorphous NiFeB Nanosheets for Enhanced Electrocatalytic N 2 Reduction

Crystal-Phase and Surface-Structure Engineering of Bi2O3 for Enhanced Electrochemical N2 Fixation to NH3

Two-Dimensional Mosaic Bismuth Nanosheets for Highly Selective Ambient Electrocatalytic Nitrogen Reduction

Modulating Lewis acidic active sites of Fe doped Bi 2 MoO 6 nanosheets for enhanced electrochemical nitrogen fixation

Engineering oxygen vacancies and low-valent bismuth at the surface of Bi2MoO6 nanosheets for boosting electrocatalytic N2 reduction

Amorphous Core/shell Ti-doped SnO2 with Synergistically Improved N2 Adsorption/activation and Electrical Conductivity for Electrochemical N2 Reduction

Nanoporous NiBi catalyst for efficient electrochemical N 2 fixation

Two-Dimensional Heterojunction Electrocatalyst: Au-Bi 2 Te 3 Nanosheets for Electrochemical Ammonia Synthesis

Heterogeneous crystalline–amorphous interface for boosted electrocatalytic nitrogen reduction to ammonia

Boosting nitrogen electrocatalytic fixation by three-dimensional TiO2−δNδ nanowire arrays

Highly Selective NH 3 Synthesis from N 2 on Electron-Rich Bi 0 in a Pressurized Electrolyzer

Modulating Nitrogen Adsorption Mode and Microenvironment of Active Sites for Boosting Electrochemical Nitrogen Reduction

Oxidation State Modulation of Bismuth for Efficient Electrocatalytic Nitrogen Reduction to Ammonia

Novel Mn-Bi-S hybrid mesoporous nanosheets as efficient electrocatalyst for nitrogen reduction reaction

Rational Design Single-Atom Modified Zr2CO2 MXene As a Promising Catalyst for Nitrogen Reduction Reaction

Architecting Bismuth Molybdate Nanoparticles with Abundant Oxygen Vacancies and High Bismuth Concentration for Efficient N2 Electroreduction to NH3

Interface hydrophobic tunnel engineering: A general strategy to boost electrochemical conversion of N2 to NH3