An Industrial Procedure for Pharmacodynamic Improvement of Metformin HCl via Granulation with Its Paracellular Pathway Enhancer Using Factorial Experimental Design
Omar Y Mady,Adam A Al-Shoubki,Ahmed Donia
DOI: https://doi.org/10.2147/DDDT.S328262
2021-11-02
Abstract:Omar Y Mady, 1 Adam A Al-Shoubki, 2 Ahmed A Donia 3 1 Pharmaceutical Technology Department, Faculty of Pharmacy, Tanta University, Tanta, Egypt; 2 Pharmaceutics and Industrial Pharmacy Department, Faculty of Pharmacy, Omar Al-Mukhtar University, Al-Bayda, Libya; 3 Department of Pharmaceutical Technology, Menoufia University, Shebeen El-Kom, Egypt Correspondence: Omar Y Mady Tel +201141819661 Email Adam A Al-Shoubki Pharmaceutics and Industrial Pharmacy Department, Faculty of Pharmacy, Omar Al-Mukhtar University, Al-Bayda, Libya Tel +218922826802 Email Background: Sorbitan monostearate is a surfactant used in the food industry. It was proved as a penetration enhancer to metformin HCl via a paracellular pathway. It is solid at room temperature and has a low melting point. Therefore, it was selected, as a granulating agent for metformin HCl. Methods: Multi-level factorial design was applied to determine the optimized formula for industrial processing. The selected formulations were scanned using an electron microscope. Differential scanning calorimetry was used to ascertain the crystalline state of a drug. A modified non-everted sac technique, suggested by the authors, was used to evaluate the in vitro permeation enhancement of the drug. To simulate the emulsification effect of the bile salt, a tween 80 was added to the perfusion solution. As a pharmacodynamic marker, blood glucose levels were measured in diabetic rats. Results: The results showed that drug permeability increases in the presence of tween 80. Drug permeability from granules increased than that of the pure drug or pure drug with tween 80. The prepared granules decreased blood glucose levels of diabetic rats than the pure drug and drug plus tween 80. There was an excellent correlation between the results of the drug permeation percent in vitro and the dropping of blood glucose level percent in vivo. Conclusion: Improving the drug permeation and consequently, the drug pharmacodynamic effect in addition to an excellent micromeritics property of the prepared drug granules showed the dual enhancement effect of the suggested industrial procedure. Therefore, we suggest the same industrial procedure for other class III drugs. Keywords: sorbitan monostearate, class III drugs, factorial design, modified non-everted sac Graphical Biopharmaceutical Classification System (BCS) is a scientific schematic system, which classifies the pharmaceutically active ingredients into four classes based on the solubility and the intestinal permeability parameters. That is because the leading factors that govern the rate and extent of drug absorption, are its solubility and intestinal permeability. Class I drugs have high water solubility and high intestinal permeability. The drugs of class II have high permeability but also have low solubility. In contrast to class II, class III drugs have high solubility but low permeability. Then, it could be expected that class IV drugs are poorly soluble and poorly permeable. 1 There are many trials to increase the solubility of drugs. Self-micro emulsifying drug delivery system (SMEDDS) is one of the techniques used to improve the drug solubility of class two. It is a pre-concentrated mixture of surfactants, co-surfactants, and lipophilic phases. This mixture forms fine droplets of emulsion with a size range of 5–100 nm when diluted with water or the body fluids in the aqueous lumen of the gut. 2 SMEDDS was also considered as an ideal carrier for the delivery of drugs class II and IV. That is due to the improvement in the in vitro and in vivo performance of poorly water-soluble drugs. 3 Metformin hydrochloride, according to BCS, is a class III drug. It has high water solubility and low intestinal permeability. Accordingly, an increase in the permeability of the drug will lead to an increase in its bioavailability, 4 and consequently, decreasing the drug dose. Self-emulsified drug delivery system (SEDDS) of metformin hydrochloride enhanced its intestinal permeability, which leads to increasing its oral bioavailability. 5–10 Tablets are the most prevalent pharmaceutical dosage form for various reasons including self-administration with to some extent an accurate dose. The drug content and drug content uniformity would be controlled by the pharmaceutical industry within a pharmacopeia range. The filling of the die of the tablet press will determine the tablet weight and consequently the dose of the drug in mg. This means the tablet press machine uses the die volume (ml 3 ) for dose (mg). The filling of the die of the tablet press machine will be done in most cases according to the bulk density o -Abstract Truncated-