Abstract:This study focuses on a green synthesis of Cu2O and Cu2O−Ag particles using ascorbic acid (LAA) as a reducing agent in the presence of two surfactants, polyethylene glycol 6000 and sodium dodecyl sulfate. The hybrid materials exhibit strongly antibacterial activity and are potential for the application in the acrylic emulsion coating. Nanomaterials based on metal oxides, especially Cu2O, have received much attention in recent years due to the many unique properties of the surface plasmon resonance they provide. The report presented the co‐precipitation method, a simple preparation method to produce Cu2O oxide particles. In addition, to improve the unique antibacterial properties of Cu2O, a proposed method is to attach Ag nanoparticles to the surface of Cu2O particles. The Cu2O and Cu2O−Ag particles were synthesized based on redox reactions using ascorbic acid (LAA) as a reducing agent. Moreover, in this experiment, two surfactants, polyethylene glycol 6000 (PEG 6000) and sodium dodecyl sulfate (SDS), were added during the manufacturing process to create particle samples and particle combinations with better properties than the original sample. Changes in the characteristics and properties of particle samples are determined by many different physical and chemical methods such as ultraviolet‐visible spectroscopy (UV‐Vis), infrared spectroscopy (IR), noise X‐ray radiation (XRD), scanning electron microscope (SEM), dynamic light scattering (DLS), energy dispersive X‐ray spectroscopy (EDS), and transmission electron microscopy (TEM). Finally, the activity against bacteria, including E. coli and S. aureus, was also tested using the agar well diffusion method to determine the zone of inhibition. The results improved the particle size value, which decreased by half to 200 nm when two additional surfactants, PEG and SDS, were added. In addition, the antibacterial ability has also been shown to increase significantly when the diameter of the bacterial inhibition zone increased significantly, reaching values of 20 mm (Cu2O/Ag/SDS) and 32 mm (Cu2O/Ag/PEG) for the E. coli bacterial strain. The initial test sample was only about 14 mm in size. The S. aureus bacterial strain also had a similar improvement trend after adding Ag to the Cu2O surface with the appearance of two surfactants, SDS and PEG. The inhibition zone diameter values reached the optimal value at 36 mm in the Cu2O/Ag/PEG particle combination sample compared to only the initial 26 mm in the Cu2O particle sample. Finally, the particle samples are added to the acrylic emulsion paint film to evaluate the changes. Positive results were obtained, such as improvement in adhesion (1.22 MPa), relative hardness (240/425), and sand drop resistance (100 L/mil) in the Cu2O/Ag/PEG particle combination sample, which showed the correctness and accuracy of the research.

High-efficiency synthesis of Cu superfine particles via reducing cuprous and cupric oxides with monoethanolamine and their antimicrobial potentials

Optimized wet-chemical synthesis of ultra-small CuO nanoparticles with high antibacterial activity

Green Synthesis of Silver Nanoparticles with High Antimicrobial Activity and Low Cytotoxicity Using Catechol-Conjugated Chitosan

Synthesis of Copper Nanoparticles Stabilized with Organic Ligands and Their Antimicrobial Properties

Biogenic Synthesis and Characterization of Chitosan-CuO Nanocomposite and Evaluation of Antibacterial Activity against Gram-Positive and -Negative Bacteria

Alpinia officinarum mediated copper oxide nanoparticles: synthesis and its antifungal activity against Colletotrichum gloeosporioides

Biogenesis of copper nanoparticles assisted with seaweed polysaccharide with antibacterial and antibiofilm properties against methicillin-resistant Staphylococcus aureus

Surface modification of cuprous oxide nanoparticles with improved chemical stability and antibacterial activity

A novel wet-chemical method of preparing highly monodispersed Cu2O nanoparticles

A green and facile synthesis route of nanosize cupric oxide at room temperature

One Pot Synthesis of Copper Oxide Nanoparticles for Efficient Antibacterial Activity

Mild Synthesis of Copper Nanoparticles with Enhanced Oxidative Stability and Their Application in Antibacterial Films

Effect of Co‐Surfactants on Properties and Bactericidal Activity of Cu2O and Hybrid Cu2O/Ag Particles

Synthesis of Ultrastable Copper Sulfide Nanoclusters Via Trapping the Reaction Intermediate: Potential Anticancer and Antibacterial Applications

Bacteria assisted green synthesis of copper oxide nanoparticles and their potential applications as antimicrobial agents and plant growth stimulants

Fabrication of Nano CuAl2O4 Spinel for Copper Stabilization and Antibacterial Application.

Synthesis of magnetic Cu-Fe3O4/carbon composite microspheres with excellent catalytic and antibacterial properties

Green synthesis of copper oxide nanoparticles using Ephedra Alata plant extract and a study of their antifungal, antibacterial activity and photocatalytic performance under sunlight

Biogenic Synthesis of Selenium and Copper Oxide Nanoparticles and Inhibitory Effect against Multi-Drug Resistant Biofilm-Forming Bacterial Pathogens

Synthesis and synergistic antibacterial efficiency of chitosan-copper oxide nanocomposites

Optimised Green Synthesis of Copper Oxide Nanoparticles and Their Antifungal Activity