Abstract:In the late 1960s, ultrafiltration was first used in clinical settings to increase, by convection, the clearance of toxic solutes in patients undergoing dialysis. Unfortunately, the efficiency of convection-based dialysis treatment, or hemofiltration (HF), was limited by the relatively low ultrafiltration coefficient of the dialyzers available at the time. Thus, the exchanged volume was low, and the corresponding clearance of low-molecular-weight solutes was insufficient with respect to the current target value of Kt/V urea. This was probably the cause of the failed improvement in the clinical and metabolic status of patients compared with standard dialysis treatment. In 1977, favorable results of the combination of diffusion and convection demonstrated the potential advantage of hemodiafiltration (HDF) over HF in terms of dialysis clearance. HDF was in fact the only means to obtain significant clearance of high-molecular-weight solutes while maintaining adequate urea clearance, whereas the increase in mean hematocrit in the erythropoietin era limited the exchanged volume in HF, in spite of the improved water permeability of the dialysis membranes. Mixed diffusive and convective clearance is less than the sum of the two parts because of reciprocal interference. Diffusive clearance mainly depends on the membrane permeability and the solute concentration gradient. New, highly permeable dialysis membranes can reach significant clearance of high-molecular-weight solutes such as Beta2 microglobulin (B2m) simply by diffusion, although in clinical settings there is also considerable ''hidden'' convection due to backfiltration. However, convection remains the best way to remove high-molecular-weight solutes, also for this kind of membrane. The ultrafiltration rate and the sieving coefficient account for the amount of convective clearance, as described in detail in the text. To define the treatment dose, the equation of Waniewsky allows the theoretical calculation of the urea clearance in HDF, both in postdilution and predilution mode. Unfortunately, no such equation is available for B2m. With a new mathematical model, well fitting with preliminary measured data although not fully validated, we calculated the relationship between urea and B2m clearance in predilution versus postdilution HDF, also considering the impact of variables such as blood and ultrafiltration flow. In particular, the predilution mode may decrease the urea clearance in comparison to hemodialysis with the same membrane and blood flow. This also applies to B2m clearance in predilution vs postdilution HDF, in spite of a marked increase in the ultrafiltration rate, at least in the more common clinical settings. In conclusion, good knowledge of the physics of solute transport is mandatory for appropriate prescription of HDF, in order to maximize both low- and high-molecular-weight solute clearance.

Investigating the Dialysis Treatment Using Hollow Fiber Membrane: A New Approach by CFD

Development and Evaluation of User‐Friendly Modeled Approach for Sustainable Polymer Membranes for Advanced Hemodialysis

An Experimental Investigation of Hollow Fiber Flow in Dialyzer

A novel theoretical model for mass transfer of hollow fiber hemodialyzers

Design and Development of a Computational Tool for a Dialyzer by Using Computational Fluid Dynamic (CFD) Model

Experimental And Numerical Analyses On The Poly(Lactide-Co-Glycolide) Hollow Fiber Membranes

Two-Dimensional Theoretical Analysis and Experimental Study of Mass Transfer in a Hollow-Fiber Dialysis Module Coupled with Ultrafiltration Operations

Influence of utilizing hemodialysis membranes outside-in on solute clearance and filtration efficiency – One step towards a novel combined lung and kidney support device

Design of robust hollow fiber membranes using an advanced co-extrusion technology for enhanced hemodialysis

Analysis of Mass-transfer Model in Dialysis Hollow Fiber Membrane

Computational analysis and experimental validation of dialysis flow rate in central venous catheters

[Evolution and physical principles of convection-based dialysis treatment]

Innovating dialysis through computational modelling of hollow-fibre haemodialysers

Numerical Simulation of Mass Transfer in Hollow Fiber Membrane Module for Membrane-Based Artificial Organs

Progress in the Applications and Modification of Dialysis-membranes

Blood Flow Distribution in Sorbent Beds: Analysis of a new Sorbent Device for Hemoperfusion

New Dialysis Technology and Biocompatible Materials

Pushing the boundaries of hemodialysis: innovations in membranes and sorbents

The changing face of dialyzer membranes and dialyzers

The scientific principles and technological determinants of haemodialysis membranes

Advances in Enhancing Hemocompatibility of Hemodialysis Hollow-Fiber Membranes