Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Clustering-Triggered Emission and Luminescence Regulation by Molecular Arrangement of Nonaromatic Polyamide-6

Amide Cluster Induced and Hydrogen Bonding Regulated Luminescence of Linear Aliphatic Polyamide 1212 with Long Alkane Chain

Aggregation-enhanced emissions of intramolecular excimers in disubstituted polyacetylenes.

Near-infrared Clusteroluminescence in Amine-Capped Polyesters

Luminogenic Polyacetylenes and Conjugated Polyelectrolytes: Synthesis, Hybridization with Carbon Nanotubes, Aggregation-Induced Emission, Superamplification in Emission Quenching by Explosives, and Fluorescent Assay for Protein Quantitation

Effects of Substitution with Donor–Acceptor Groups on the Properties of Tetraphenylethene Trimer: Aggregation-Induced Emission, Solvatochromism, and Mechanochromism

Clustering-Triggered Emission Mechanism of Sulfur Ester-Polyacrylamide Aqueous Solution

White Light Emission of Multi-Chromophore Photoluminescent Nanoparticles Using Polyacrylate Scaffold Copolymers with Pendent Polyfluorene Groups

1,8-Naphthalimide-based Highly Emissive Luminophors with Various Mechanofluorochromism and Aggregation-Induced Characteristics.

Significantly Red-Shifted Emissions of Nonconventional AIE Polymers Containing Zwitterionic Components

High Efficiency Luminescent Liquid Crystalline Polymers Based on Aggregation-Induced Emission and “jacketing” Effect: Design, Synthesis, Photophysical Property, and Phase Structure

Aggregation-induced emission of non-conjugated poly(amido amine)s: Discovering, luminescent mechanism understanding and bioapplication

Achieving Swift and Distinct Luminescent Modulation Through Manipulating Molecular Motion in Polymers

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Regulation of clusterization-triggered phosphorescence from a non-conjugated amorphous polymer: a platform for colorful afterglow

Unprecedented Multicolor Photoluminescence from Hyperbranched Poly(amino ester)s

Photoluminescence Enhancement By Controllable Aggregation And Polymerization Of Octanuclear Gold Clusters

Cluster-induced aggregation in polyurethane derivatives with multicolour emission and ultra-long organic room temperature phosphorescence

Polymerization-Induced Clusteroluminescence of Poly(cyclic carbonate)s

Emerging Clusteroluminescence from Complexes between Carbonyl‐Based Polymers and Organic Base

Effect of Aggregation on Thermally Activated Delayed Fluorescence and Ultralong Organic Phosphorescence: QM/MM Study