Deposition of Visible Light-Active C-Doped Titania Films via Magnetron Sputtering Using CO2 as a Source of Carbon

Rachan Klaysri,Marina Ratova,P. Praserthdam,P. Kelly
DOI: https://doi.org/10.3390/nano7050113
IF: 5.3
2017-05-01
Nanomaterials
Abstract:Doping of titanium dioxide with p-block elements is typically described as an efficient pathway for the enhancement of photocatalytic activity. However, the properties of the doped titania films depend greatly on the production method, source of doping, type of substrate, etc. The present work describes the use of pulsed direct current (pDC) magnetron sputtering for the deposition of carbon-doped titania coatings, using CO2 as the source of carbon; ratios of O2/CO2 were varied through variations of CO2 flow rates and oxygen flow control setpoints. Additionally, undoped Titanium dioxide (TiO2) coatings were prepared under identical deposition conditions for comparison purposes. Coatings were post-deposition annealed at 873 K and analysed with scanning electron microscopy (SEM), X-ray diffreaction (XRD), atomic force microscopy (AFM), and X-ray photoelectron spectroscopy (XPS). The photocatalytic properties of the thin films were evaluated under ultraviolet (UV) and visible light irradiation using methylene blue and stearic acid decomposition tests. Photoinduced hydrophilicity was assessed through measurements of the water contact angle under UV and visible light irradiation. It was found that, though C-doping resulted in improved dye degradation compared to undoped TiO2, the UV-induced photoactivity of Carbon-doped (C-doped) photocatalysts was lower for both model pollutants used.
What problem does this paper attempt to address?