Abstract:In a previous study (Beuter et al. 1986) the authors modeled a stepping motion using a three-body linkage with four degrees of freedom. Stepping was simulated by using three task parameters (i.e., step height, length, and duration) and sinusoidal joint angular velocity profiles. The results supported the concept of a hierarchical control structure with open-loop control during normal operation. In this study we refine the dynamic model and improve the simulation technique by incorporating the dynamics of the leg after landing, adding a foot segment to the model, and preprogramming the complete step motion using cycloids. The equations of the forces and torques developed on the ground by the foot during the landing phase are derived using the Lagrangian method. Simulation results are compared to experimental data collected on a subject stepping four times over an obstacle using a Selspot motion analysis system. A hierarchical control model that incorporates a learning process is proposed. The model allows an efficient combination of open and closed loop control strategies and involves hardwired movement segments. We also test the hypothesis of cycloidal velocity profiles in the joint programs against experimental data using a novel curve-fitting procedure based on analytical rather than numerical differentiation. The results suggest multiobjective optimization of the joint's motion. The control and learning model proposed here will help the understanding of the mechanisms responsible for assembling selected movement segments into goal-directed movement sequences in humans.

Modeling of control and learning in a stepping motion