Investigation the effect of length-to-diameter ratio on six-DOF helical and zigzag maneuvers of the SUT glider with internal actuators

Ali Hasanvand,Mohammad Saeed Seif
DOI: https://doi.org/10.1016/j.oceaneng.2024.116819
IF: 5
2024-02-01
Ocean Engineering
Abstract:Underwater gliders (UGs) are used for seabed data collection due to their low power consumption, which is an advantage for extending endurance in deep seas. The geometrical characteristics directly affect the stability and performance of these types of robots in terms of their endurance. This study aimed to determine the effect of the body length-to-diameter ratio on maneuverability during zigzag and helical maneuvers. For this, the theoretically derived formulas based on non-linear hydrodynamic coefficients for the body and wing have been described in six degrees of freedom (six-DOF). The model and theoretical formulas have been validated by experimental tests on the Sharif University of Technology glider (SUT glider). The non-linear six-DOF dynamic model as a model for analysis has been utilized to investigate the length-to-diameter ratio in UG's maneuverability. Furthermore, in the helical maneuver, the length-to-diameter ratio affected the kinematics and performance of the UG. L/D = 10 had the lowest tactical diameter; however, L/D = 4 had the highest yaw rate. Also, in the zigzag maneuver, L/D = 4 had the most horizontal and vertical velocities but demonstrated more efficiency ( U/W ) than other ratios.
engineering, civil, ocean, marine,oceanography
What problem does this paper attempt to address?