Abstract:Although 4Ce4YSZ has high corrosion resistance, it faces challenges concerning its sinterability and ionic conductivity. Therefore, we studied destabilization behavior caused by corrosion and oxygen vacancy ordering according to ZnO doping. Powders of (4Ce4YSZ)1−x(ZnO)x (x = 0.5, 1, 2, 4 mol%) were synthesized using the sol-gel method. With the addition of ZnO, the cubic phase increased, and secondary phases were not observed. The (111) peak showed a higher angle shift in ZnO-doped 4Ce4YSZ compared to 4Ce4YSZ, and TEM-SAED revealed a reduction in the spacing of the (011)t plane, suggesting lattice contraction due to the substitution of the smaller Zn2+ (60 Å) for Zr4+ (84 Å) in the lattice. The local atomic structure analysis was conducted using EXAFS to investigate the oxygen vacancy ordering behavior. Zr K-edge Fourier transform data revealed a decrease in the Zr-O1 peak intensity with an increasing amount of ZnO doping, indicating an increase in oxygen vacancies. The Zr-O1 peak position shifted to the right, leading to an increase in the Zr-O1 interatomic distance. In the Y K-edge Fourier transform data, the Y-O1 peak intensity did not decrease, and there was little variation in the Y-O1 interatomic distance. These results suggest that the oxygen vacancies formed due to ZnO doping are located in the neighboring oxygen shell of Zn, rather than in the neighboring oxygen shells of Y and Zr. Impedance measurements were conducted to measure the conductivity, and as the amount of ZnO doping increased, the total conductivity increased, while the activation energy decreased. The increase in oxygen vacancies by ZnO doping contributed to the enhancement of conductivity, and it is considered that these created oxygen vacancies did not interact with Zn2+ and did not form defect associations. Fluoride-based molten salts were introduced to the specimens to assess the corrosion behavior in a molten salt environment. Yttrium depletion layers (YDLs) were formed on the surfaces of all specimens due to the leaching of yttrium. However, Ce remained relatively stable at the interface according to EDS line scans, suggesting a reduction in the phase transformation (cubic, tetragonal to monoclinic) typically associated with yttrium leaching in YSZ.

Influence of Zr substitution on the electrical and dielectric properties of the Ce0.6-xZrxY0.4O2-δ solid solutions

Influence of (Zn1/3Ta2/3)4+ substitution for Zr4+ in Ce2Zr3(MoO4)9 and the impact on the crystal structure and microwave dielectric properties

Electrical and dielectric properties of optimized cubic structure with promising morphological texture in Ce0.8Zr0.2O2

Defect and Transport Model of Ceria–Zirconia Solid Solutions: Ce0.8Zr0.2O2−δ—An Electrical Conductivity Study

Influence of Zirconium (Zr4+) Substitution on the Crystal Structure and Optical and Dielectric Properties of Sr0.8Mg0.2(Sn1- xZrx)O3 Ceramics

Effect of (zn1/3nb2/3)4+ Co-Substitution on the Microwave Dielectric Properties of Ce2Zr3(MoO4)9 Ceramics

Effect of cerium on yttrium-doped barium zirconate with a ZnO sintering aid: Grain and grain boundary protonic conduction

Effect of Ce substitution on the local magnetic ordering and phonon instabilities in antiferromagnetic DyCrO3perovskites

Enhanced Thermal Stability and Oxygen Storage Capacity for CexZr1-xO2 (x = 0.4−0.6) Solid Solutions by Hydrothermally Homogenous Doping of Trivalent Rare Earths

Interface Effects on the Ionic Conductivity of Doped Ceria / Yttria-stabilized Zirconia Heterostructures

Electrical conductivity of mixed conductors (YO1.5) x.(CeO2)y.(ZrO2)1-x-y

Influence of component manipulation on the structural, mechanical, thermophysical and electrical properties of La0·2Ce0.2Nd0.2(ZrxY1−x)0.4O2−δ high-entropy ceramics

Oxygen Vacancy Ordering and Molten Salt Corrosion Behavior of ZnO-Doped CeYSZ for Solid Oxide Membranes

Influence of Rare-Earth Doping Content and Type on Phase Transformation and Transport Properties in Highly Doped CeO2

Characterization of high Zr/Ce ratio Ba(Zr, Ce, Y)O3-δ proton conductors: investigating the impact of Y on materials properties

Electrical Conductivity of Ceria Co-Doped with Zr and Re (Re=la,y)

Effects of (Mg1/3Sb2/3)4+ substitution on the structure and microwave dielectric properties of Ce2Zr3(MoO4)9 ceramics

Influence of B-site substituent Ce on thermophysical, oxygen diffusion, and mechanical properties of La2Zr2O7

High-temperature Dielectric Properties of BaZr 0.8 Y 0.2 O 3-Δ Ceramics

High-temperature Dielectric Relaxations in (ce, Y) Codoped BaZrO3 Ceramics

Study on the structure change and oxygen vacation shift for Ce1-xSmxO2-y solid solution