Abstract:Local geometric information and discontinuity features are key aspects of the analysis of the evolution and failure mechanisms of unstable rock blocks in rock tunnels. This study demonstrates the integration of terrestrial laser scanning (TLS) with distinct element method for rock mass characterization and stability analysis in tunnels. TLS records detailed geometric information of the surrounding rock mass by scanning and collecting the positions of millions of rock surface points without contact. By conducting a fuzzy K -means method, a discontinuity automatic identification algorithm was developed, and a method for obtaining the geometric parameters of discontinuities was proposed. This method permits the user to visually identify each discontinuity and acquire its spatial distribution features (e.g. occurrences, spacings, trace lengths) in great detail. Compared with hand mapping in conventional geotechnical surveys, the geometric information of discontinuities obtained by this approach is more accurate and the identification is more efficient. Then, a discrete fracture network with the same statistical characteristics as the actual discontinuities was generated with the distinct element method, and a representative numerical model of the jointed surrounding rock mass was established. By means of numerical simulation, potential unstable rock blocks were assessed, and failure mechanisms were analyzed. This method was applied to detection and assessment of unstable rock blocks in the spillway and sand flushing tunnel of the Hongshiyan hydropower project after a collapse. The results show that the noncontact detection of blocks was more labor-saving with lower safety risks compared with manual surveys, and the stability assessment was more reliable since the numerical model built by this method was more consistent with the distribution characteristics of actual joints. This study can provide a reference for geological survey and unstable rock block hazard mitigation in tunnels subjected to complex geology and active rockfalls.

Reconstitution method for tunnel spatiotemporal deformation based on 3D laser scanning technology and corresponding instability warning

A 3D Laser Scanning Mountain Tunnel Processing Method Based on ICP Algorithm

Research on Tunnel Construction Monitoring Method Based on 3D Laser Scanning Technology

Physical Model Test and Application of 3D Printing Rock-Like Specimens to Laminated Rock Tunnels

Deformation monitoring of noncircular tunnels based on 3D laser scanning

Research on deformation monitoring of tunnel engineering based on 3D laser scanning

Full-Section Deformation Monitoring of High-Altitude Fault Tunnels Based on Three-Dimensional Laser Scanning Technology

Experiment and Application of NATM Tunnel Deformation Monitoring Based on 3D Laser Scanning

An Automatic Data Processing Method for Deformation Analysis and Visualization of Tunnel Cross Sections Using Laser Scanning Data

3D Laser Scanning Acquisition and Modeling of Tunnel Engineering Point Cloud Data

Systematic Approach for Tunnel Deformation Monitoring with Terrestrial Laser Scanning

A Method for Convergent Deformation Analysis of a Shield Tunnel Incorporating B-Spline Fitting and ICP Alignment

Tunnel Deformation Analysis Based on Lidar Points

Application of 3D laser scanning on NATM tunnel deformation measurement during construction

Visual Monitoring Technology of the Tunnel 3D Laser Scanning and Engineering Applications

A NEW APPROACH FOR SUBWAY TUNNEL DEFORMATION MONITORING: HIGH-RESOLUTION TERRESTRIAL LASER SCANNING

Tunnel Cross-Section Deformation Monitoring Based on Mobile Laser Scanning Point Cloud

A Coal Mine Tunnel Deformation Detection Method Using Point Cloud Data

Automatic identification of rock discontinuity and stability analysis of tunnel rock blocks using terrestrial laser scanning

Method for Tunnel Displacements Calculation Based on Mobile Tunnel Monitoring System

Study on the 3D laser scanning technology for tunnel inspection