Degradation of biomass tar catalyzed by Fe/Ce supported on diatomite-based foam ceramics

Chen Yang,Yunji Pang,GangHui Li,Yisheng Chen,Huan Li
DOI: https://doi.org/10.1007/s13399-023-04124-w
IF: 4.05
2023-04-12
Biomass Conversion and Biorefinery
Abstract:Foam ceramics with excellent pore structure were prepared by using mineral diatomite with abundant reserves. It is used for catalytic reforming of biomass pyrolysis gas. Fe 2 O 3 and CeCl 3 were loaded on foam ceramics as active materials to explore the effect of using them as catalyst supports. The experimental results show that diatomite-based foam ceramics (DBFC) have good catalytic performance. At 750 °C, the gas yield was increased by 6.5% and the liquid yield was reduced by 16.04% under the catalysis of diatomite-based foam ceramics. After repeated use tests, the results show that the anti-deactivation activity is higher, and the catalytic effect of the second use is better than that of the third use, but still better than that of the first use. When DBFC is used as catalyst carrier, Fe 2 O 3 loaded on it has better catalytic performance. At 750 °C, the gas yield increased by 13.14% and the liquid yield decreased by 33.54%. The analysis of gas phase products shows that the use of DBFC will increase H 2 , CH 4 , and CO 2 in the syngas, but will reduce the yield of CO, and the increase of CO 2 yield is greater than that of H 2 and CH 4 . Fe 2 O 3 loading leads to the highest gas productivity, but the proportion of CO 2 in syngas is also the highest and LHV is the lowest.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?