Abstract:<h3 class="article-section__sub-title section1"> Objective</h3><p>Phenylethyl resorcinol (PR) has been used widely in the personal care industry as a novel skin lightening ingredient. Surprisingly, there is only limited information describing the physicochemical properties of this active. Therefore, the primary objective of this study was to perform a comprehensive characterization of PR. A secondary objective was to investigate the delivery of this molecule to mammalian skin.</p><h3 class="article-section__sub-title section1"> Methods</h3><p>PR was characterised using Differential Scanning Calorimetry (DSC), Thermogravimetric Analysis (TGA), and Nuclear Magnetic Resonance (NMR). A new high‐performance liquid chromatographic (HPLC) method for analysis of PR was developed and validated. The logP (octanol water partition coefficient), value, solubility and short‐term stability of PR in a series of vehicles were also determined using HPLC. The evaporation of the selected vehicles was examined using Dynamic Vapour Sorption (DVS). The permeation profiles of PR were investigated under finite dose conditions in porcine and human skin.</p><h3 class="article-section__sub-title section1"> Results</h3><p>The melting point of PR was determined to be 79.13 °C and the measured logP (octanol water partition coefficient) at 21 °C was 3.35 ± 0.03. The linearity of the HPLC analytical method was confirmed with an r<sup>2</sup> value of 0.99. Accuracy of the method was evaluated by average recovery rates at three tested concentrations, and the values ranged from 99 – 106%. The limit of detection (LOD) and limit of quantification (LOQ) were 0.19 and 0.57 <i>μ</i>g/mL, respectively. The solubility of PR in PG, DMI, glycerol was within the range of 367 to 877 mg/mL. The stability of PR in tested solvents were also confirmed by the 72 h stability studies. From the DVS studies, 70‐125% of applied formulations were recovered at 24h. The permeation through porcine skin at 24 h ranged from 4 to 13 <i>μ</i>g/cm<sup>2</sup>, while the corresponding amounts of PR delivered through human skin were 2 to 10 <i>μ</i>g/cm<sup>2</sup>. </p><h3 class="article-section__sub-title section1"> Conclusion</h3><p>The physicochemical properties of PR confirm it is suitable for dermal delivery. In this study, propylene glycol was the most promising vehicle for PR delivery to human skin. Future work will expand the range of vehicles studied and explore the percutaneous absorption from more complex formulations.</p><p>This article is protected by copyright. All rights reserved.</p>

Use of an In Vitro Skin Parallel Artificial Membrane Assay (Skin-PAMPA) as a Screening Tool to Compare Transdermal Permeability of Model Compound 4-Phenylethyl-Resorcinol Dissolved in Different Solvents

A comparative study of the in vitro permeation of 2-phenoxyethanol in the skin PAMPA model and mammalian skin

Assessment of skin permeability to topically applied drugs by skin impedance and admittance

Lanolin-Based Synthetic Membranes for Transdermal Permeation and Penetration Drug Delivery Assays

Impact of solvent dry down, vehicle pH and slowly reversible keratin binding on skin penetration of cosmetic relevant compounds: I. Liquids

Physiologically-based pharmacokinetic model of in vitro porcine ear skin permeation for drug delivery research

Alternatives to Biological Skin in Permeation Studies: Current Trends and Possibilities

Impact of solvent dry down, phase change, vehicle pH and slowly reversible keratin binding on skin penetration of cosmetic relevant compounds: II. Solids

Ability of biomimetic chromatography and physicochemical systems to predict the skin permeation of neutral compounds. A comparison study

Usefulness of Artificial Membrane, Strat-M®, in the Assessment of Drug Permeation from Complex Vehicles in Finite Dose Conditions

Quantitative structure permeability relationships for phenolic compounds applied to human epidermal membranes in various solvents

Pig Ear Skin as an In-vitro Model for Human Skin Permeability

Transdermal Permeation of Drugs in Various Animal Species

The Development of an Artificial Skin Membrane Mimicking the Lipid Bilayer Structure for in Vitro Permeation Study

Parafilm® M and Strat-M® as skin simulants in in vitro permeation of dissolving microarray patches loaded with proteins

Evaluation of an in vitro percutaneous permeation model with two oxidative hair dyes

Influence of skin model on in vitro performance of drug-loaded soluble microneedle arrays

Polycyclic aromatic hydrocarbon skin permeation efficiency in vitro is lower through human than pigskin and decreases with lipophilicity

Characterization and topical delivery of phenylethyl resorcinol

Percutaneous penetration and absorption of parathion using human and pig skin models in vitro and human skin grafted onto nude mouse skin model in vivo

Comparison of the metabolism of 10 chemicals in human and pig skin explants