Total Replacement of Knee Using Metal/Polyethylene Two-Part Prosthesis

M. Freeman,S. Swanson,A. Zahir
DOI: https://doi.org/10.1177/003591577206500432
1972-04-01
Proceedings of the Royal Society of Medicine
Abstract:Comment The usual cause of pain and stiffness in the shoulder-joint is extra-articular and the only common cause of articular degeneration is rheumatoid arthritis. Prosthetic replacement of the humeral head after fracture by a Neer (1955, Journal of Bone & Joint Surgery, 37A, 215) prosthesis often results in a satisfactory range of movement, although this is by no means always certain. In rheumatoid arthritis the results of replacing the humeral head alone are, however, less satisfactory. This may be due to upward subluxation of the prosthesis in the glenoid which frequently occurs, trapping the rotator cuff between the greater tuberosity and the acromion. In addition, experience with other joints has shown that movement of metal on abnormal cartilage often leads to failure. A total shoulder replacement (UK patent application number 42197/69) has been designed in the Biomedical Engineering Department of the Institute of Orthopedics in collaboration with Mr David Goddard (Figs 1 and 2). This has so far been used in 5 patients suffering from rheumatoid arthritis. In each of these cases (2 of which are reported above) the alternative to total replacement would have been arthrodesis. This could have been expected to relieve pain, but would not have resulted in such a good range of movement and would have placed an extra strain on other joints. Acknowledgment: We are grateful to Professor 0 Lewis of St Bartholomew's Hospital Medical College for providing dissecting-room facilities during the development of the prosthesis.
What problem does this paper attempt to address?