Abstract:Moving vehicles pick up the particulates/dust on the road surface, and the wake structures behind the vehicle determine the dispersion of these particles. This study aims at understanding the characteristics of particle dispersion in the turbulent wake of a moving vehicle. The flow over a simplified vehicle model known as the Ahmed body is analysed. Experimental measurements and computational simulations of particle dispersion in the near wake of Ahmed body are presented. Unsteady simulations are performed for the prediction of the flow topology and particle dispersion around the Ahmed body, at (Reynolds no. based on vehicle model length ' l '), the rear slant angle of Ahmed body considered is . Governing equations solved are unsteady Reynolds Averaged Navier–Stokes (URANS) equations, and the turbulence model employed was SST . Experiments involved the release of fog particles (Ethylene-Glycol, ) from a source behind the model. Dispersion of the particles was measured in the wind tunnel using a laser sheet for fog particle visualisation at three downstream locations, X=1, 2, and 3, at . It was observed that the flow structure in the near wake of the model consisted of two counter-rotating spanwise vortices and a pair of trailing vortices. URANS simulations capture both the turbulent flow features in the near wake. Experimental results were compared with the URANS simulation results, and it was found that the dominant turbulent structures (recirculation vortices and trailing vortices) in the near wake contribute to particle dispersion. The dispersion patterns obtained are dependent on the size and strength of turbulent structures. The URANS simulations perform reasonably well in capturing the vertical dispersion of particles. However, they do not accurately estimate the lateral dispersion of smoke particles. The lateral dispersion is underestimated by the URANS simulations.

Aerodynamic study of a moving Ahmed body by numerical simulation

A Quasi-Steady 3-DoFs Sectional Aerodynamic Model: Preliminary Results

Numerical Investigation of Unsteady Aerodynamic Characteristics of A Pitching Missile

Study of the automotive aerodynamic performance affected by entrance structure of forecabin

Numerical simulation of the transient aerodynamic phenomena induced by passing manoeuvres

MATHEMATICAL MODELING OF THE AERODYNAMIC FLOW AROUND A BODY UNDER VARIOUS CONDITIONS OF ITS MOVEMENT

A numerical investigation of the asymmetric wake mode of a squareback Ahmed body – effect of a base cavity

Simulation and feedback control of the Ahmed body flow exhibiting symmetry breaking behaviour

Particle dispersion in the turbulent wake of an Ahmed body: An experimental and computational study

Aerodynamics of the square-back Ahmed body under rainfall conditions

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

Aerodynamic Characteristics of Human Movement Behaviours in Full-Scale Environment: Comparison of Limbs Pendulum and Body Motion

Aerodynamic optimization of mixed platoon Ahmed body vehicles based on response surface method

AhmedML: High-Fidelity Computational Fluid Dynamics Dataset for Incompressible, Low-Speed Bluff Body Aerodynamics

Experimental Calculation of Added Masses for the Accurate Construction of Airship Flight Models

A Comparison Between Experimental Life Road Simulation and Computational Fluid Dynamics and Fluid Structure Interaction for Sedan Car

A bio-inspired device for drag reduction on a three-dimensional model vehicle

The Influence of Forebody Topology on Aerodynamic Drag and Aeroacoustics Characteristics of Squareback Vehicles using CAA

Numerical Investigation of Variation Stroke Plane Effect on Aerodynamic Performance of a 2D Flapping Airfoil Naca 0012 in Hovering Flight

Numerical and experimental investigation on the dynamic airflow of human movement in a full-scale cabin

Modeling, Aerodynamic and Crash Simulation on Car Using Fluient