Abstract:This study tried to use electroflocculating precipitated waste to prepare a Si@Al adsorbent by simply mixing sodium silicate at a mass ratio of 4:1 and calcining at 200 °C for 2 h. The adsorbent was low cost, high efficiency, and could remove a variety of contaminants (organic pollutants, antibiotics, and metal ions) from water. In this study, adsorbent characterization and pollutant adsorption experiments were carried out. The results showed that: Si@Al adsorbent had uniform particles, distinct layers, a loose porous appearance, and the internal structure was scattered without a crystal structure. The optimal adsorption conditions for tetracycline were as follows: dosage of adsorbent 2.0 g/L, reaction time 10 min, pH = 4.5, and tetracycline removal rate of 97.13%. The optimal adsorption conditions for MB (MB stands for methylene blue) were an adsorption dosage of 4.0 g/L, a reaction time of 15 min, pH = 4.5–8.5, and a removal rate of 96.39%. The optimal adsorption conditions for Cu were a 2.0 g/L dosage of adsorbent, a reaction time of 30 min, a pH of 8.5, and a highest removal rate of 97.47%. It was worth noting that the effect of temperature on TC, MB and Cu was not significant. At the same time, the kinetic fitting results showed that the adsorption of MB was more consistent with the quasi-second-order kinetic model, with R2 ranging from 0.9788 to 1.0000. The adsorption of TC and Cu was more consistent with the quasi-first-order kinetic model, with R2 ranging from 0.9598 to 0.9999 and 0.9844 to 0.9988, respectively. According to the results of thermodynamics, kinetics and zero potential point, the adsorption of tetracycline and methylene blue was mainly a physical adsorption, multilayer heterogeneous or single-layer homogeneous adsorption process. The adsorption of Cu was categorized as multi-layer heterogeneous chemical adsorption. The co-existing substances had little effect on the properties of the adsorbent, and the adsorbent could be recycled 5 times. Compared with other adsorbents, the results showed that the adsorbents had obvious advantages in terms of the raw material source, preparation method, time cost and removal effect. This study provided a “waste into treasure, green and efficient” multi-pollutant adsorption method.

Removal of ammonium, phosphate, and sulfonamide antibiotics using alum sludge and low-grade charcoal pellets

Evaluating Biochar and Its Modifications for the Removal of Ammonium, Nitrate, and Phosphate in Water.

Adsorption of Sulfonamides in Aqueous Solution on Reusable Coconut-Shell Biochar Modified by Alkaline Activation and Magnetization

Simultaneous Removal of Phosphate and Phenanthrene by Alum Aided with Low Amounts of Surfactant‐modified Bentonite

Enhanced Adsorption of Sulfonamides by Attapulgite-Doped Biochar Prepared with Calcination

Development of low-cost iron mixed porous pellet adsorbent by mixture design approach and its application for arsenate and arsenite adsorption from water

Evaluation of potential adsorbents for simultaneous adsorption of phosphate and ammonium at low concentrations

Recovery of Phosphate From Aqueous Solution by Mg/Ca-Modified Biochar Derived From Dewatered Dry Sludge and Waste Almond Shells and Its Potential Application

Versatile Strategy of Sulfanilamide Antibiotics Removal Via Microalgal Biochar: Role of Oxygen-Enriched Functional Groups.

Promoting adsorption of organic pollutants via tailoring surface physicochemical properties of biomass-derived carbon-attapulgite

Removal of Phosphate from Aqueous Solution Using Magnesium-Alginate/Chitosan Modified Biochar Microspheres Derived from Thalia Dealbata

Remediation of Aqueous Phosphate Agricultural Runoff Using Slag and Al/Mg Modified Biochar

A three-step process to produce biochar with good magnetism, high specific surface area, and high levels of nitrogen doping for the efficient removal of sulfamethoxazole

Preparation and Application of Si@Al Adsorbents for Different Pollutants Removal from Aqueous Solution

Enhanced removal of ammonium nitrogen from aqueous solutions using a novel biochar derived from millet shells through both static adsorption and dynamic column experiments

High performance removal of sulfamethoxazole using large specific area of biochar derived from corncob xylose residue

Efficient Elimination of Inorganic/Organic Pollutants by Fe3O4/biochar@sodium Alginate Gel Beads

Simultaneous reclaiming phosphate and ammonium from aqueous solutions by calcium alginate-biochar composite: Sorption performance and governing mechanisms

Enhanced removal of sulfonamide antibiotics from water by phosphogypsum modified biochar composite

Preparation of a Series of Highly Efficient Porous Adsorbent PGMA-N Molecules and Its Application in the Co-Removal of Cu(II) and Sulfamethoxazole from Water

Simultaneous adsorption of ammonia and phosphate using ferric sulfate modified carbon/zeolite composite from coal gasification slag