Abstract:The efficient development of selective materials for uranium recovery from wastewater and seawater is crucial for the utilization of uranium resources and environmental protection. The potential of graphene oxide (GO) as an effective adsorbent for the removal of environmental contaminants has been extensively investigated. Further modification of the functional groups on the basal surface of GO can significantly enhance its adsorption performance. In this study, a novel poly(amidoxime-hydroxamic acid) functionalized graphene oxide (pAHA-GO) was synthesized via free radical polymerization followed by an oximation reaction, aiming to enhance its adsorption efficiency for U(VI). A variety of characterization techniques, including SEM, Raman spectroscopy, FT–IR, and XPS, were employed to demonstrate the successful decoration of amidoxime and hydroxamic acid functional groups onto GO. Meanwhile, the adsorption of U(VI) on pAHA-GO was studied as a function of contact time, adsorbent dosage, pH, ionic strength, initial U(VI) concentration, and interfering ions by batch-type experiments. The results indicated that the pAHA-GO exhibited excellent reuse capability, high stability, and anti-interference ability. Specially, the U(VI) adsorption reactions were consistent with pseudo-second-order and Langmuir isothermal adsorption models. The maximum U(VI) adsorption capacity was evaluated to be 178.7 mg/g at pH 3.6, displaying a higher U(VI) removal efficiency compared with other GO-based adsorbents in similar conditions. Regeneration of pAHA-GO did not significantly influence the adsorption towards U(VI) for up to four sequential cycles. In addition, pAHA-GO demonstrated good adsorption capacity stability when it was immersed in HNO3 solution at different concentrations (0.1–1.0 mol/L) for 72 h. pAHA-GO was also found to have anti-interference ability for U(VI) adsorption in seawater with high salt content at near-neutral pH condition. In simulated seawater, the adsorption efficiency was above 94% for U(VI) across various initial concentrations. The comprehensive characterization results demonstrated the involvement of oxygen- and nitrogen-containing functional groups in pAHA-GO in the adsorption process of U(VI). Overall, these findings demonstrate the feasibility of the pAHA-GO composite used for the capture of U(VI) from aqueous solutions.

Assembly of three-dimensional ultralight poly(amidoxime)/graphene oxide nanoribbons aerogel for efficient removal of uranium(VI) from water samples

Preparation of Graphene/graphene Nanoribbons Hybrid Aerogel and Its Application for the Removal of Uranium from Aqueous Solutions

A facile method for preparing three-dimensional graphene nanoribbons aerogel for uranium(VI) and thorium(IV) adsorption

Extremely efficient aerogels of graphene oxide/graphene oxide nanoribbons/sodium alginate for uranium removal from wastewater solution

Fabrication of a Novel Electrospun Polyvinyl Alcohol/polyacrylic Acid Nanofiber Adsorbent Loading with Montmorillonite or Zeolite for Uranium (VI) Removal

Synthesis of Graphene Oxide Nanoribbons/chitosan Composite Membranes for the Removal of Uranium from Aqueous Solutions

Poly amidoxime functionalized carbon nanotube as an efficient adsorbent for removal of uranium from aqueous solution

High-Efficiency Adsorption of Uranium from Wastewater Using Graphene Oxide/Graphene Oxide Nanoribbons/Chitosan Nanocomposite Aerogels

Amidoximated graphene/konjac glucomannan composite gel for uranium extraction from saline lake brine

A porous multifunctional and magnetic layered graphene oxide/3D mesoporous MOF nanocomposite for rapid adsorption of uranium(VI) from aqueous solutions

Hydrogel polyamidoxime shell layer constructed on cyclized polyacrylonitrile nanofibrous mats for efficient uranium extraction from seawater

Efficient removal of U(VI) from aqueous solution using poly(amidoxime-hydroxamic acid) functionalized graphene oxide

Three-dimensional Graphene Oxide/phytic Acid Composite for Uranium(vi) Sorption

Highly enhanced adsorption performance to uranium(VI) by facile synthesized hydroxyapatite aerogel

One-step cross-linking of amino-rich chitosan aerogels for efficient and selective adsorption of uranium from radioactive nuclear wastewater

High-Capacity Amidoxime-Functionalized β-Cyclodextrin/Graphene Aerogel for Selective Uranium Capture

Graphene Aerogel Capsulated Precipitants for High Efficiency and Rapid Elimination of Uranium from Water

Synthesis and characterization of poly(TRIM/VPA) functionalized graphene oxide nanoribbons aerogel for highly efficient capture of thorium(IV) from aqueous solutions

Efficient uranium adsorption by amidoximized porous polyacrylonitrile with hierarchical pore structure prepared by freeze-extraction

Preparation of porous chitosan/carboxylated carbon nanotube composite aerogels for the efficient removal of uranium(VI) from aqueous solution

Photothermal enhanced separation and extraction of uranium: Zwitterion/chitosan functionalized graphene oxide aerogel with lamellar structure and microchannels