Abstract:Throughout the last decade, many assistive robots for people with disabilities have been developed; however, researchers have not fully utilized these robotic technologies to entirely create independent living conditions for people with disabilities, particularly in relation to activities of daily living (ADLs). An assistive system can help satisfy the demands of regular ADLs for people with disabilities. With an increasing shortage of caregivers and a growing number of individuals with impairments and the elderly, assistive robots can help meet future healthcare demands. One of the critical aspects of designing these assistive devices is to improve functional independence while providing an excellent human-machine interface. People with limited upper limb function due to stroke, spinal cord injury, cerebral palsy, amyotrophic lateral sclerosis, and other conditions find the controls of assistive devices such as power wheelchairs difficult to use. Thus, the objective of this research was to design a multimodal control method for robotic self-assistance that could assist individuals with disabilities in performing self-care tasks on a daily basis. In this research, a control framework for two interchangeable operating modes with a finger joystick and a chin joystick is developed where joysticks seamlessly control a wheelchair and a wheelchair-mounted robotic arm. Custom circuitry was developed to complete the control architecture. A user study was conducted to test the robotic system. Ten healthy individuals agreed to perform three tasks using both (chin and finger) joysticks for a total of six tasks with 10 repetitions each. The control method has been tested rigorously, maneuvering the robot at different velocities and under varying payload (1-3.5 lb) conditions. The absolute position accuracy was experimentally found to be approximately 5 mm. The round-trip delay we observed between the commands while controlling the xArm was 4 ms. Tests performed showed that the proposed control system allowed individuals to perform some ADLs such as picking up and placing items with a completion time of less than 1 min for each task and 100% success.

A Novel Control System for Intelligent Nursing Robot

Modeling and Control of Differential-Drive Chassis for a Homecare Assistive Robot

An IoT-Enabled Telerobotic-Assisted Healthcare System Based on Inertial Motion Capture.

A Network Control System of Mobile Robot for Elderly Care.

Analysis, Design, and Experimental Research of a Novel Wheelchair-Stretcher Assistive Robot

A Roboticized Multi-Function Nursing Bed and Its Control System

A Novel Gesture Recognition System for Intelligent Interaction with a Nursing-Care Assistant Robot

Learning and Control in Assistive Robotics for the Elderly

Implementation of a Versatile Intelligent Vehicle with Tracking and Remote Control for Hospital or Nursing Homes

Design and Implementation on Multi-Function Smart Wheelchair

Control of a Wheelchair-Mounted 6DOF Assistive Robot With Chin and Finger Joysticks

Design and Experiment of Multi-Modal Intelligent Elderly Assisted Wheelchair Robot

Control System Design of Mobility Scooter with Four In-Wheel Motors

Design and Safety Control of a High-Payload Nursing Robotic Arm with Tactile Skin.

A Novel Human-Like Control Framework for Mobile Medical Service Robot

Research Progress and Prospect of Nursing Robot

Planning and Control for Robot-Assisted Feeding System Towards the Disabled

Progress and Prospect of Nursing Robot

Adaptive neural network controller of an intelligent commode robot for trajectory tracking

A comprehensive study on Mecanum wheel-based mobility and suspension solutions for intelligent nursing wheelchairs

Research on key technology of multifunctional elderly-assistant & walking-assistant robot