Abstract:Background and objectives: Few quantitative studies have investigated the temperature dependent viscoelastic properties of cartilage tissue. Cartilage softens and can be reshaped when heated using laser, RF, or contact heating sources. The objectives of this study were to: (1) measure temperature dependent flexural storage moduli and mechanical relaxation in cartilage, (2) determine the impact of tissue water content and orientation on these mechanical properties, and (3) use these measurements to estimate the activation energy associated with the mechanical relaxation process. Study design/materials and methods: Porcine nasal septal cartilage specimens (30 x 10 x 2 mm) were deformed using a single cantilever arrangement in a dynamic thermomechanical analyzer. Stress relaxation measurements were made at discrete temperatures ranging from 25 to 70 degrees C in response to cyclic deformation (within the linear viscoelastic region). The time and temperature dependent behavior of cartilage was measured using frequency multiplexing techniques (10-64 Hz), and these results were used to estimate the activation energy for the phase change using the Williams-Landel-Ferry (WLF) equation and the Arrhenius kinetic equation. In addition, the effect of tissue orientation was examined with specimens oriented in both transverse and longitudinal directions at room temperature. Results: The storage moduli of porcine cartilage decreased with increasing temperature, and a critical change in mechanical properties was observed between 58 and 60 degrees C with a reduction in the storage modulus by 85-90%. The shift of the stress relaxation behavior from viscoelastic solid to viscoelastic liquid was observed between 50 and 57 degrees C and likely corresponds to the transition temperature region in which structural changes in the tissue occur. The storage moduli for transverse and longitudinally oriented specimens were 19-22 and 14-16 MPa, respectively at ambient temperature. Reducing the water content (<10% mass loss) by allowing it to dry under ambient conditions resulted in reduction in the storage modulus by 31-36%. The activation energy associated with the mechanical relaxation of cartilage was 147 kJ/mole at 60 degrees C. This value was calculated by measuring stress-strain relationship under conditions where linear viscoelastic behavior was observed (0.09-0.15% of strain) within the transition temperature region (58-60 degrees C). Conclusions: The anisotropic mechanical behavior of cartilage was quantitatively analyzed in the transversely and longitudinally oriented specimens. Viscoelastic behavior appeared to be strongly dependent on the water content. Using empirically determined estimates of the transition zone temperature range accompanying stress relaxation, the activation energy for stress relaxation was calculated using time and temperature superposition theory and WLF equation. Further investigation of the molecular changes, which occur during laser irradiation, may assist in understanding the thermal and mechanical behavior of cartilage and how the reshaping process might to be optimized.

A Computational Evaluation of the temperature distribution generated by thermal splints designed to treat knee pain

Computational Study of Thermal Effects of Large Blood Vessels in Human Knee Joint.

Investigation on Three-Dimensional Temperature Field of Human Knee Considering Anatomical Structure

Analyzing the Thermal Characteristics of Three Lining Materials for Plantar Orthotics

Thermal analysis of ultrathin, compliant sensors for characterization of the human skin

Investigation of phase change material based cool pack performance in vests for personalized thermal comfort in extremely hot climatic conditions: Model development and case studies

Effect of Phase Change Material Cooling Vests on Body Thermoregulation and Thermal Comfort of Patients With Paraplegia: A Human Subject Experimental Study

Numerical simulation of cooling effect of human-PCM-clothing model in hot environments

Analytical Model for Thermoregulation of the Human Body in Contact with a Phase Change Material (PCM) Cooling Vest

Temperature measurement and control system for transtibial prostheses: Functional evaluation

Experimental study on the effectiveness of the PCM cooling vest in persons with paraplegia of varying levels

Anatomical Model-Based Finite Element Analysis of the Combined Cryosurgical and Hyperthermic Ablation for Knee Bone Tumor.

The effect of moving heat source in DPL model on viscoelastic biological tissues during during thermal treatment applications

Influence of thermophysical and acoustic properties on temperature elevation at muscle/bone interface induced by ultrasound hyperthermia

Flexible and Photo-Responsive Composite Phase Change Materials for Thermal Therapy

Characterization of temperature dependent mechanical behavior of cartilage

Quantitative assessment of pain-related thermal dysfunction through clinical digital infrared thermal imaging

Experimental Study on Heat Transfer During Melting in Metal and Carbon Foam Saturated with Phase-Change Materials for Temperature Control in Electronic Devices

Preliminary Application of Infrared Thermography to Monitoring of Skin Temperature Asymmetries in Professional Padel Players

Towards a Flexible Wrist-Worn Thermotherapy and Thermoregulation Device

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation