Abstract:Airway mucus is a complex material with both viscoelastic and viscoplastic properties that vary with healthy and pathological conditions of the lung. In this study, the effects of these conditions on airway closure are examined in a model problem, where an elastoviscoplastic (EVP) single liquid layer lines the inner wall of a rigid pipe and surrounds the air core. The EVP liquid layer is modelled using the Saramito-HB model. The parameters for the model are obtained for the mucus in healthy, asthma, chronic obstructive pulmonary disease (COPD), and cystic fibrosis (CF) conditions by fitting the rheological model to the experimental data. Then the liquid plug formation is studied by varying the Laplace number and undisturbed liquid film thickness. Airway closure is a surface-tension-driven phenomenon that occurs when the ratio of the pulmonary liquid layer thickness to the airway radius exceeds a certain threshold. In previous studies, it has been found that airway epithelial cells can be lethally or sublethally damaged due to the high peak of the wall stresses and stress gradients during the liquid plug formation. Here we demonstrate that these stresses are also related to the EVP features of the liquid layer. Yielded zones of the liquid layer are investigated for the different mucus conditions, and it is found that the liquid layer is in a chiefly unyielded state before the closure, which indicates that this phase is dominated by the elastic behavior and solvent viscosity. This is further confirmed by showing that the elastic coefficient is one of the most critical parameters determining whether the closure occurs. This parameter also largely affects the closure time. The wall stresses are also investigated for the pathological and healthy cases. Their peaks for COPD and CF are found to be the highest due to the viscoelastic extra stress contribution. Contrary to the Newtonian case, the wall stresses for COPD and CF do not smoothly relax after closure, as they rather remain effectively almost as high as the Newtonian peak. Moreover, the local normal wall stress gradients are smaller for the COPD and CF liquid layer due to their higher stiffness causing a smaller curvature at the capillary wave. The local tangential wall stress gradients are also shown to be smaller for these cases because of the slower accumulation of the liquid at the bulge. https://doi.org/10.1103/PhysRevFluids.8.053102 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

The effect of viscoelasticity in an airway closure model

Effects of elastoviscoplastic properties of mucus on airway closure in healthy and pathological conditions

Surface-tension-driven evolution of a viscoplastic liquid coating the interior of a cylindrical tube

Effects of Surface Tension and Yield Stress on Mucus Plug Rupture: A Numerical Study

Dynamics of liquid plugs in prewetted capillary tubes: from acceleration and rupture to deceleration and airway obstruction

Epithelial cell deformation during surfactant-mediated airway reopening: a theoretical model

Enhanced microscopic dynamics in mucus gels under a mechanical load in the linear viscoelastic regime

Influence of cytoskeletal structure and mechanics on epithelial cell injury during cyclic airway reopening

Liquid plugs in narrow tubes: application to airway occlusion

Effects of continuous and discrete boundary conditions on the movement of upper-convected maxwell and Newtonian mucus layers in coughing and sneezing

Dynamics of a liquid plug in a capillary tube under cyclic forcing: memory effects and airway reopening

Microscopic Airway Reopening Through Cascades of Plugs Ruptures

A computational simulation of the effect of alveolar exudates properties on airway opening pressure in patients with COVID-19

Curvature-driven transport of thin Bingham fluid layers in airway bifurcations

An Estimation of Mechanical Stress on Alveolar Walls During Repetitive Alveolar Reopening and Closure

Effect of inhaled air temperature on mucus dynamics in the proximal airways

A Biphasic Theory for the Viscoelastic Behaviors of Vocal Fold Lamina Propria in Stress Relaxation.

Numerical simulation of pulmonary airway reopening by the EOS-based multiphase lattice Boltzmann method

The effects of viscoelasticity on residual strain in aortic soft tissues

Stress & strain in mechanically nonuniform alveoli using clinical input variables: a simple conceptual model

Modeling lung tissue dynamics and injury under pressure and impact loading