An Electron Optical Survey of Iron Oxide o Films Produced in H 20 , 1 . 5 % LiOH , and ULiOT / EDTA ( pH 11 ) Solutions at 316 0 C

L. R.,M.

Abstract:In the exploration of steel corrosion mechanisms pertinent to steam power generation, Holl has been investigated as an alkalizing agent to form protective oxide films on Ioiler walls. Steel capsules treated in three different ways, (a) with H20, (b) with 1.5% UiOH solution, and (c) with LiOH/ EDITA rpl I I) at 316°(., formed films which, in ihe initial stages of development, were shown to be Fea( ). However, the crystallite size, the degree of orientation, and the film uniformity and continuity, determined by electron microscopy and diffraction, varied with the method and length of treatment. The fihln foirmed hy distilled water showed small (1000 to 2000 A), oriented crystals With sharply delineated areas of growth. When the l.iOH solotion was used in the treatnent, larger crystals were formed. but flaws were still noticeable after 24 hours. With the LiOH/EDTA solution, the growth of the crystals was very rapid, forming a thick. coherent film on the metal, which should offer excellent protection iagainst corrosion. INTRODUCTION series of tests, LiOH was found to be superior to In the course of exploraiion of stee corrosion NaOH in corrosion inhibition when these alkalies meh m pare used independently in solution with no other a ime n hanisms pertinent to steam power generation, additives. attention has recently been given to LiOH s an In connection with further studies of corrosion alkalizing medium for treatment of steel bt mechanisms in these systems, the techniques of elevatedl temperatures (1 ,2). LiOH cannot be electron microscopy and electron diffraction are simply substituted for NaOH in the conventional being utilized as an aid in the analysis of the Navy low-phosphate treatment for boiler water strutured of the go pc ss s of te primril becuseof postio ofL6P0 onthe structure and of the growth processes of protective primarily because of deposition of LibPOe on the films. These techniques have been used to examine boiler walls (3). Investigations have been underthe initial processes of oxide film formation in taken to evaluate LiOH boiler water treatments H20, 1.5% LiOH solution, and LiOH/EDTA where an organic chelating agent, ethylenedisolution at 316TC (conditions related to boiler aminetetraacetic acid (EDTA), is used instead of operation) to ascertain whether the morphology Jphosphate to prevent hard scale formation by the and/or composition of the surface oxide differed alkaline earth ions which are always present in systematically with the treatments and whether sea water distillate. Preliminary studies in capsuch differences, if found, could be correlated with stile systems at this laboratory and in model the relative degrees of corrosion inhibition preboilers at the Marine Engineering Laboratory have viously observed for these additive systems. indicated that this type of treatment is preferable from the standpoint of prevention of boiler wall corrosion to the low-phosphate control treatment EXPERIMEAN AL TECHNIQUES presently being used by the Navy (3). In the same AND EQUIPMENT SThree test solutions, prepared from distilled * NRI. Problem C05-22; Project RR 001.01-43-4758. This is an interim water and reagent grade chemicals, were used in report on one phase of the problem: work is continuing on the problem. te experiment (adistille wer only Manuscript submitted May 24, 1966. these experiments: (a) distilled water only,