Abstract:As a typical harmful VOC pollutant, benzene vapor is of great significance for its efficient purification treatment. Benzene vapor is a typical contaminant of VOCs which is the culprit of various diseases, so it is very meaningful to research how to purify the benzene vapor efficiently. Paper material is a kind of porous material with low density, high porosity and high mechanical strength. In this paper, two different kinds of paper, WFP (wood fiber paper) and CFP (ceramic fiber paper), are used as the porous substrates. Paper based silica gel adsorbent was made by gluing repeatedly, immersing the paper porous substrate in JN-30 silica sol and then drying them in oven several times. The surface morphology and structure of two kinds of paper materials were observed by the scanning electron microscopy (SEM). The adsorption properties of the samples which are made from WFP and CPF are tested by using the multi station absorption apparatus. The results show that the two porous substrates are of strong adhesive ability of silica, and the silica adhesive rate of the WFP and CFP reaches 3.38 g/g and 8.66 g/g after 6 times gluing. With the increase of gluing times, the silica adhesive rate of both materials is increasing, but after the gluing times reaches 4 times, growth of silica adhesive rate becomes significantly lower. The adsorption performance test results show the strong adsorption ability of the paper-based silica adsorbents on benzene vapor, both a good adsorption rate and adsorption capacity: it takes less than 30 min to achieve 80％ of maximum adsorption capacity under 0.1 benzene vapor partial pressure, and the maximum adsorption capacity reaches 100 mg/g under 0.8 benzene vapor partial pressure. With the increase of the gluing times, the paper-based silica gel adsorbents' adsorption capacity of benzene vapor first rises and then drop. In addition, the dynamic adsorption model of the paper-based silica gel adsorbents was fitted by the piecewise dynamic adsorption model. It was found that the dynamic adsorption process under the low pressure was divided into 2 stages: the early stage and later stage. In the early stage of adsorption, the adsorption capacity of materials is strong and adsorption quantity increases rapidly; in the later stage of adsorption, adsorption quantity increases much slower and gradually reaches saturation. By comparing isothermal adsorption curves of two different paper-based silica gel adsorbents, it can be found that, with the increase of gluing times, adsorption capacity of the WFP based silica gel adsorbents increases first and then decreases and it reaches the maximum at 4 times gluing. In contrast, the isothermal adsorption ability of CFP based silica gel adsorbents is basically unchanged after 4 times of gluing. Based on the fitting study of the adsorption isotherm with the Langmuir equation and the D-R equation, it was found that the adsorption isotherm was also divided into 2 parts: the low-pressure area and the high-pressure area. In addition, the adsorption characteristic curve is obtained by segmentation fitting the experimental results.

Adsorption of volatile benzene series compounds by surface-modified glass fibers: kinetics, thermodynamic adsorption efficiencies, and mechanisms

Adsorption properties of paper based silica gel adsorbents for benzene vapor

Adsorption Characteristics of Bisphenol-A on Tailored Activated Carbon in Aqueous Solutions

Porous Glass Beads As A New Adsorbent to Remove Sulfur-Containing Compounds

Adsorption characteristics of water vapor on the hypercrosslinked polymeric adsorbent

Adsorption Characteristics Of Benzene-Chlorobenzene Vapor On Hypercrosslinked Polystyrene Adsorbent And A Pilot-Scale Application Study

Novel Hydrophobic Pdvb/R-Sio2 for Adsorption of Volatile Organic Compounds from Highly Humid Gas Stream

A Concise Review on Porous Adsorbents for Benzene and Other Volatile Organic Compounds

Removal of Benzene and Methyl Ethyl Ketone Vapor: Comparison of Hypercrosslinked Polymeric Adsorbent with Activated Carbon.

Study on the adsorption behavior of benzene mixture in water on different materials by headspace gas chromatography

Experimental evaluation of benzene adsorption in the gas phase using activated carbon from waste biomass

Adsorption Phenomenon of VOCs Released from the Fiber-Reinforced Plastic Production onto Carbonaceous Surface

Fluorine-tailed glass fibers for adsorption of volatile perfluorinated compounds via F-F interaction

Improving the adsorption performance of non-polar benzene vapor by using lignin-based activated carbon

Adsorption of benzene and toluene from aqueous solution using a composite hydrogel of alginate-grafted with mesoporous silica

Sorptive process and breakthrough behavior of odorous volatile compounds on inert surfaces

Adsorption equilibrium and dynamics of gasoline vapors onto polymeric adsorbents

Adsorption of trace polar methy-ethyl-ketone and non-polar benzene vapors on viscose rayon-based activated carbon fibers

Adsorption materials for volatile organic compounds (VOCs) and the key factors for VOCs adsorption process: A review

Influence of pore volume and surface area on benzene adsorption capacity of activated carbons in indoor environments

High-performance gas-phase adsorption of benzene and toluene on activated carbon: response surface optimization, reusability, equilibrium, kinetic, and competitive adsorption studies