MARINE PROPELLERS

J. Kerwin
DOI: https://doi.org/10.1146/annurev.fluid.18.1.367
Abstract:Propellers produce thrust through the production of lift by their rotating blades. Propeller hydrodynamics i therefore part of the broader field of lifting-surface theory, which includes such varied applications as aircraft, hydrofoil boats, ship rudders, and sailboat keels. Air and water propellers have much in common from a theoretical point of view, particularly if one’s attention is restricted to air propellers operating at low Mach numbers (where compressibility effects are negligible) and to water propellers operating without cavitation. The cross sections of most lifting surfaces are also similar in appearance, being designed to produce a force at right angles to their motion through the fluid (lift) with a minimum force parallel to their direction of motion (drag). In spite of these fundamental similarities, air and water propellers generally look very different. The reason is that propellers for ships are limited, for practical reasons, in diameter, and they are also limited by cavitation in the amount of lift per unit blade area that they can produce. As a result, marine propellers have blades that are much wider in relation to their diameter than would be found in aircraft propellers. In addition, propellers are generally located in close proximity to the stern of a ship. This choice is based both on consideration of propulsive efficiency and on such practical matters as machinery arrangement and vulnerability to damage. Since the flow near the stern is nonuniform, an inevitable consequence is the development of vibratory forces on the propeller blades and on the hull. Decisions concerning the number of blades and the shape of the blade outline are influenced to a great extent by the need to minimize this excitation. As an example, Figure 1 shows a photograph of a recently designed propeller for a seismic exploration vessel. The computational model used in
What problem does this paper attempt to address?