Abstract:Combining collocated high-rate Global Navigation Satellite Systems (GNSS) and accelerometers produces broadband seismogeodetic displacements. However, accelerometer data must be heavily downweighted due to their baseline errors originating primarily in instrument rotations, and therefore their contribution to seismogeodetic displacements is seriously underestimated. We further introduced a gyroscope into this classic seismogeodesy to mitigate baseline errors and formulated advanced six-degree-of-freedom (6-DOF) seismogeodesy without undervaluing accelerometer data. A shake table holding one GNSS antenna, four accelerometers, and one gyroscope was used to simulate waveforms from the 2010 Mw 7.2 El Mayor-Cucapah earthquake. We found that the displacements derived from the 6-DOF seismogeodesy were up to 68% more accurate than those from the classic seismogeodesy over 0.04-0.4 Hz. Moreover, broadband rotations containing the permanent components were also generated, which were unachievable by integrating gyroscope data. We believe that the 6-DOF seismogeodesy is capable of improving both source rupture studies of large earthquakes and high-rise monitoring under strong seismic waves. Plain Lauguage Summary The faulting mechanism of large earthquakes has always been an enigma to the seismology community. One important reason is that we cannot measure accurately the low-frequency (e.g., <0.1 Hz) displacements at near-source stations using existing techniques. In particular, seismometer recovered low-frequency displacements are normally biased and incomplete due to intrinsic instrument limitations; Global Navigation Satellite Systems is able to obtain unbiased broadband (e.g., 0-5 Hz) displacements, but they are over 2 orders of magnitude noisier than seismometer measurements. We therefore develop an advanced technique that combines collocated Global Navigation Satellite System receivers, accelerometers, and gyroscopes to capture highly accurate earthquake-induced displacements and also rotations, spanning the frequencies from 0 to tens of hertz. We demonstrate that the accuracy of low-frequency displacements can be improved by up to 68% in contrast to traditional measuring techniques, and the permanent rotations can also be recovered, which can never be achieved by only inertial sensors (i.e., gyroscopes and accelerometers). We believe that this new technique can assist in deepening our understanding of the rupture process of large earthquakes, and the broadband rotations have the potential to unveil more unknowns about earthquake sources and Earth media beyond our present knowledge. We can get more prepared for future destructive earthquakes.

Seismological Processing of Six Degree-of-Freedom Ground-Motion Data

Six-degree-of-freedom Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers and Gyroscopes

A Review of Rotational Seismology Area of Interest from a Recording and Rotational Sensors Point of View

Six-Degree-of-Boradband Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers, and Gyroscopes

Rotational motions of the Ms7.0 Jiuzhaigou earthquake with ground tilt data

Seismic Anisotropy From 6C Ground Motions of Ambient Seismic Noise

Deep Underground Observation of Rotational Motions Induced by M6.1 Hualien Earthquake

The Development of a New IFOG-Based 3C Rotational Seismometer

Numerical Experiments of Moment Tensor Inversion with Rotational Ground Motions

Design and Implementation of Programmable Multi-Parametric 4-Degrees of Freedom Seismic Waves Ground Motion Simulation IoT Platform

Near-Field Measurement of Six Degrees of Freedom Mining-Induced Tremors in Lower Silesian Copper Basin

Simulation of Rotational ground motion in the near field region

Design and sensitivity of a 6-axis seismometer for gravitational wave observatories

Effect of rotational components of strong ground motions on behavior of high-rise buildings with outrigger and belt-truss system

Rotational and Translational Motions Induced by the Ms6.4 Yunan Yangbi Earthquake Recorded by Co-Located FOGs and Seismometer

Active platform stabilisation with a 6D seismometer

Application of Six-Component Ambient Seismic Noise Data for High-Resolution Imaging of Lateral Heterogeneities

PIONEERS: a 6DoF motion sensor to measure rotation and tides in the Solar System

Sensitivity and control of a 6-axis fused-silica seismometer

Rotation-induced Magnetic Field in a Coil Magnetometer Generated by Seismic Waves