Abstract:Current and future interferometeric gravitational-wave detectors are limited predominantly by shot noise at high frequencies. Shot noise is reduced by introducing arm cavities and signal recycling, however, there exists a tradeoff between the peak sensitivity and bandwidth. This comes from the accumulated phase of signal sidebands when propagating inside the arm cavities. One idea is to cancel such a phase by introducing an unstable optomechanical filter. The original design proposed in [Phys.~Rev.~Lett.~{\bf 115},~211104 (2015)] requires an additional optomechanical filter coupled externally to the main interferometer. Here we consider a simplified design that converts the signal-recycling cavity itself into the unstable filter by using one mirror as a high-frequency mechanical oscillator and introducing an additional pump laser. However, the enhancement in bandwidth of this new design is less than the original design given the same set of optical parameters. The peak sensitivity improvement factor depends on the arm length, the signal-recycling cavity length, and the final detector bandwidth. For a 4~km interferometer, if the final detector bandwidth is around 2~kHz, with a 20~m signal-recycling cavity, the shot noise can be reduced by 10 decibels, in addition to the improvement introduced by squeezed light injection. We also find that the thermal noise of the mechanical oscillator is enhanced at low frequencies relative to the vacuum noise, while having a flat spectrum at high frequencies.

Dual-recycled cavity-enhanced Michelson interferometer for gravitational-wave detection.

Length sensing and control of a Michelson interferometer with Power Recycling and Twin Signal Recycling cavities

Sensing and control scheme for the inteferometer configuration with an L-shaped resonator

Merging L-shaped resonator with Michelson configuration for kilohertz gravitational-wave detection

Converting the signal-recycling cavity into an unstable optomechanical filter to enhance the detection bandwidth of gravitational-wave detectors

A back-linked Fabry-Perot interferometer for space-borne gravitational wave observations

Michelson interferometer with diffractively-coupled arm resonators in second-order Littrow configuration

Achieving resonance in the Advanced LIGO gravitational-wave interferometer

Dual balanced readout for scattered light noise mitigation in Michelson interferometers

Interferometer Techniques for Gravitational-Wave Detection

A cryogenic silicon interferometer for gravitational-wave detection

Double optical spring enhancement for gravitational wave detectors

Demonstration of a squeezed light enhanced power- and signal-recycled Michelson interferometer

Experimental investigation of a control scheme for a zero-detuning resonant sideband extraction interferometer for next-generation gravitational-wave detectors

Laser Interferometer Gravitational Wave Detectors—the Challenges

Quantum Enhanced Interferometer for Kilohertz Gravitational Wave Detection

Gravitational wave detection with single-laser atom interferometers

Coupling of lateral grating displacement to the output ports of a diffractive Fabry-Perot cavity

High-Frequency Gravitational-Wave Detection Using a Chiral Resonant Mechanical Element and a Short Unstable Optical Cavity

High-Performance Telescope System Design for Space-Based Gravitational Waves Detection

Design and experimental demonstration of a laser modulation system for future gravitational-wave detectors