Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Fault diagnosis of an automated guided vehicle with torque and motion forces estimation: A case study

Trajectory tracking and fault detection algorithm for automatic guided vehicle based on multiple positioning modules

A fault-tolerant control strategy for multiple automated guided vehicles

A Fuzzy Virtual Actuator for Automated Guided Vehicles

Fault diagnosis and fault tolerant control for distributed drive electric vehicles through integration of active front steering and direct yaw moment control

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Algorithms and Methods for the Fault-Tolerant Design of an Automated Guided Vehicle

A Novel Fault Detection, Identification and Prediction Approach for Autonomous Vehicle Controllers Using SVM

Robust Path Tracking Control for Autonomous Vehicle Based on a Novel Fault Tolerant Adaptive Model Predictive Control Algorithm

A Hybrid Model-Data Vehicle Sensor and Actuator Fault Detection and Diagnosis System

Actuator fault-tolerant control allocation for cooperative transportation of multiple omnidirectional mobile robots

Fault-Tolerant Control for Intelligent Electrified Vehicles Against Front Wheel Steering Angle Sensor Faults During Trajectory Tracking

Path tracking fault-tolerant control of intelligent distributed drive electric vehicle based on sliding mode observer

A Martingale Posterior-Based Fault Detection and Estimation Method for Electrical Systems of Industry

Rack force fault tolerance estimation of steer-by-wire system under different resolver faults based on sensor flows

Estimation of Vehicle's Vertical and Lateral Tire Forces Considering Road Angle and Road Irregularity

GPS Signal Fault Diagnosis for Unmanned Rollers Based on Total Disturbance Observation and Support Vector Machine

Advanced digital twin-enabled fault diagnosis framework for unmanned vehicle systems

Scheduling the tasks of multiple AGVs in a fault-tolerant control way

Sensitivity-Based Fault Detection and Isolation Algorithm for Road Vehicle Chassis Sensors

Fuzzy Adaptive Event-Triggered Path Tracking Control for Autonomous Vehicles Considering Rollover Prevention and Parameter Uncertainty