Facile in-situ polymerization of polyaniline-functionalized melamine sponge preparation for mass spectrometric monitoring of perfluorooctanoic acid and perfluorooctane sulfonate from biological samples

Liang Qi,Jicheng Gong

DOI: https://doi.org/10.1016/j.chroma.2019.460777

2020-04-12

Abstract:In this present work, a novel polyaniline-functionalized melamine sponge (PMs) was successfully prepared using a simple unstirred in-situ polymerization process. The PMs was characterized using a scanning electron microscope and contact angle measurements. Its adsorption performance was initially determined via dye adsorption assays, and the conditions affecting the synthesis including polymerization time, acidity, molar ratio, and number and sizes of raw melamine sponge were optimized. The PMs was then used as an efficient adsorbent for the development of a novel, low-cost method for the detection of two representative perfluorinated chemicals, perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS), using ultra-performance liquid chromatography-triple quadrupole mass spectrometry (UPLC-QqQ-MS/MS) with the internal standard method. To achieve the best extraction efficiency with this method, several variables were optimized, including adsorption time, pH value, the number of PMs, and desorption conditions. Calibration graphs showed a good linear degree at concentration ranging from 0.1 to 50 μg L-1 for PFOA and 0.01-10 μg L-1 for PFOS, with a coefficient of detection R2 = 0.998. The intra-day and inter-day relative standard deviations were found to range from 5.9% to 8.2% for PFOA, and 5.5% to 7.7% for PFOS. Under these optimized conditions, the method was successfully used to measure PFOA and PFOS content in real human serum and urine samples, with average spiked recoveries ranging from 79% and 91% for PFOA, and 81% to 87% for PFOS.