Recent Advances In External Cavity Modelocked Lasers Using Semiconductor Optical Amplifiers
P. Delfyett,S. Gee,H. Shi,B. Mathason,G. Alphonse,J. Connolly
DOI: https://doi.org/10.1109/CLEOPR.1997.610561
1997-07-14
Abstract:Recently semiconductor optical amplifiers have become the device of choice in semiconductor diode laser scenarios which require an external cavity owing to the extremely low facet reflectivity requirement. In this talk, recent results will be presented on the 1) physical operating mechanisms associated with hybrid modelocked diode lasers, 2) the generation of simultaneous 4 wavelength modelocked operation at 2.5 GHz for WDMTDM networks, and 3) the dynamics of all optical clock recovery oscillators using modelocked diode lasers. We will present experimental measurements of the intracavity gain, saturable absorption, intracavity pulse shapes and spectrograms. These results were obtained by taking the compressed output of the modelocked diode laser and reinjecting it into the external cavity and performing time resolved gain and saturable absorption measurements. Intracavity intensity profiles and their corresponding spectrograms were obtained by cross-correlating the intracavity pulses with the compressed output in a LiIO, crystal and monitoring the generated SHG intensity and its spectrum. The results of these measurements show that the nonlinearity associated with gain depletion, coupled with group velocity dispersion leads to the generation of asymmetric pulse shapes with quasi-parabolic instantaneous frequency chirp, while saturable absorption and GVD contribute to linearizing the chirp. The end result of these dynamics produce optical pulses with fast rise edges, with slower trailing edges, which are highly compressible with linear dispersion compensation. We also show these intracavity dynamics can allow for the development of an external cavity modelocked diode laser which can produce 4 independently tunable wavelengths, each modelocked at a repetition rate of 2.5 GHz, producing optical pulses of 12 psec in duration. The tuning characteristics show that the wavelength separation between each channel can be varied between -0.3 nm to over 2 nm, while the 4 wavelength packet can be tuned over 20 nm. This data suggests that operating the laser with over 20 wavelengths should be possible. In addition, preliminary evidence suggests that coherent coupling between the independent wavelength channels exists, owing to intracavity four wave mixing. This is verified by observing four wave mixing sidebands generated directly within the laser cavity, which occupy the identical frequency spectrum as the independently generated wavelength channels. Finally we demonstrate the use of passively modelocked diode lasers as all optical clock recovery oscillators. In these experiments, an optical pulse train is generated from a hybridly modelocked diode laser. By passing the pulse train through a second SOA which is pulse-biased, the optical pulse train can be modulated. Once the optical pulse train is modulated, a small portion of the optical intensity is injected into the optical clock recovery oscillator (passive modelocked diode laser). By varying the duty cycle of the injected pulse train, one can obtain fundamental information regarding the dynamics of the optical clock recovery process. In these experiments we demonstrate a minimum injection power of <6 p,W in order to obtain clock synchronization, with a total jitter of <93 fsec. Measurements of the total fractional locking bandwidth of 3.1K3 of the data clocking rate is obtained, with a large asymmetry in the locking bandwidth owing to causality. In addition, synchronization of 1/50th of the data rate is also achieved without jitter degradation.