Abstract:The release of microplastics (MPs) especially those with sizes less than 10 μm from effluent of wastewater treatment plants (WWTPs) is one of the major sources of plastics into aquatic environment. To reduce the discharge of MPs into environment, it is essential to further enhance their removal efficiencies in WWTPs. In present study, to boost the removal performance of MPs in sand filtration systems (units that commonly employed in WWTPs to remove colloidal pollutants), six types of biochar fabricated from three raw biomass materials (i.e. lignin, cellulose, and woodchips) at two pyrolysis temperatures (400 °C and 700 °C) was respectively amended into sand columns as thin permeable layer. We found that adding all six types of biochar into sand columns as thin permeable layer could greatly improve the retention of MPs with the diameter of 1 μm under either slow (4 m/d) or fast flow rates (160 m/d) due to the high adsorption capability of biochar. Woodchip-derived biochar exhibited the highest MPs retention performance, which was followed by cellulose-derived biochar and then lignin-derived biochar. Moreover, for biochar derived from three raw biomasses, increasing pyrolysis temperature could improve MPs retention performance. The direct observation of real-time plastics retention processes on different types of biochar via a visible flow chamber showed that woodchip-derived biochar especially that fabricated at 700 °C exhibited more MPs trapping processes relative to lignin and cellulose-derived biochar due to their more complex surface morphology. Thus, the highest MPs retention performance was achieved in sand columns with amendment by 1 wt% woodchip-derived biochar fabricated at 700 °C. More importantly, we found that for these modified sand filtration column systems, complete MPs removal could be achieved in real river water and actual sewage water, in multiple filtration cycles, longtime filtration process (100 pore volumes injection) as well as with interval flow conditions. Moreover, biochar could be regenerated and reused as thin permeable layer to effectively remove MPs. The results of this study clearly showed that biochar especially woodchip-derived biochar fabricated at 700 °C had the potential to immobilize MPs especially those with small sizes in WWTPs.

Age differences of arrested and crash-involved drinking drivers.

A Comparative Analysis for the Development and Recovery Processes of Different Types of Clogging in Lab-Scale Vertical Flow Constructed Wetlands.

The Influence Mechanism of Bioclogging on Pollution Removal Efficiency of Vertical Flow Constructed Wetland.

Effects of Organic Carbon on Nitrification Rate in Fixed Film Biofilters

Enzyme Treatment Improves the Performance of Laboratory-Scale Vertical Flow Constructed Wetland.

Synergistic Effect of Chitosan-Based Sludge Aggregates CS@NGS Inoculum Accelerated the Start-Up of Biofilm Reactor Treating Aquaculture Effluent: Insights into Performance, Microbial Characteristics, and Functional Genes.

Clogging in Vertical Flow Constructed Wetlands: Causes for Clogging and Influence of Decontamination

Addition of biochar as thin preamble layer into sand filtration columns could improve the microplastics removal from water.

Experimental research of microbial-induced clogging in sands

Slow sand filtration of raw wastewater using biochar as an alternative filtration media

Seawater biofiltration pre-treatment system: comparison of filter media performance

Set partitioning of Gaussian integer constellations and its application to two-dimensional interleaver design

Impacts of aeration and biochar addition on extracellular polymeric substances and microbial communities in constructed wetlands for low C/N wastewater treatment: Implications for clogging

Integrated Metagenomic and Physiochemical Analyses to Evaluate the Potential Role of Microbes in the Sand Filter of A Drinking Water Treatment System

Water quality and hydraulic performance of biochar amended biofilters for management of agricultural runoff

Shifting to biology promotes highly efficient iron removal in groundwater filters

Biological clogging of geotextiles under discontinuous fermentation scenario

The Effect of Different Carbon Sources on Biofouling in Membrane Fouling Simulators: Microbial Community and Implications.

Biochar from co-pyrolysis of biological sludge and sawdust in comparison with the conventional filling media of vertical-flow constructed wetlands for the treatment of domestic-textile wastewater

Enhanced biofilm formation and denitrification in slow sand filters for advanced nitrogen removal by powdery solid carbon sources addition

Application of an indigenous microorganisms-based fixed-bed GAC-biofilm reactor for passive and sustainable treatment of oil sands process water through combined adsorption and biodegradation processes