Density and confinement effects on fluid velocity slip

Carlos Corral-Casas,Yichong Chen,Matthew K. Borg,Livio Gibelli,and Livio Gibelli

DOI: https://doi.org/10.1103/physrevfluids.9.034201

IF: 2.895

2024-03-12

Physical Review Fluids

Abstract:Understanding the velocity slip of fluids in channels of molecular length scales is essential for accurately manipulating their flow in engineering applications, such as in water desalination or, by reversing the process, osmotic power generation. This study addresses two major open questions, namely (a) the range of validity of the Navier-Stokes equations with slip boundary conditions in describing fluid flows within channels of molecular confinement, and (b) the effect of fluid density and confinement as well as surface properties, such as microscopic roughness and curvature, on fluid slippage along walls. Using a hard-sphere fluid model and describing the fluid-wall interactions by the Maxwell scattering kernel, an event-driven molecular dynamics simulation study was performed in planar and cylindrical channels of different sizes and accommodation coefficients with varying fluid densities. The results show that the well-known criterion for the slip solution, which is valid in rarefied conditions, also holds for a dense gas, i.e., the predictive accuracy improves with decreasing Knudsen numbers, as long as the channel size is larger than about ten molecular diameters. We also find that the key quantity influencing the friction coefficient of a fluid is the peak density at the walls, rather than the nominal density, the fluid confinement, or the channel curvature, as found in previous studies. In particular, higher nominal densities lead to higher density peaks, and therefore a decrease in slip, while tighter confinements lead to lower density peaks, and therefore an increase in slip, regardless of channel geometry. Furthermore, the velocity slip depends on the microscopic roughness via the Smoluchowski factor. These findings are a stepping stone towards a deeper understanding of the molecular mechanisms underlying fluid velocity slip in molecular-scale channels. https://doi.org/10.1103/PhysRevFluids.9.034201 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

physics, fluids & plasmas

What problem does this paper attempt to address?

The paper attempts to address the following two main issues:

1. **Validity Criteria for Slip Solutions**: Determine the range of validity for the Navier-Stokes equations with slip boundary conditions in describing fluid flow at the molecular scale. Specifically, researchers aim to understand whether these equations are applicable for describing fluid flow within molecular-scale channels.

2. **Factors Influencing Fluid Slip**: Investigate the impact of fluid density, fluid confinement (i.e., the ratio of channel size to molecular diameter), and surface properties (such as microscopic roughness and curvature) on fluid slip along the wall. The goal of the study is to understand how these factors collectively influence the slip characteristics of the fluid.

Using a hard-sphere fluid model and Maxwell scattering kernel to describe the interaction between the fluid and the wall, and employing event-driven molecular dynamics simulations (EDMD), simulations were conducted in channels of different sizes and in parallel plate and cylindrical channels. The results indicate that for channel sizes greater than approximately 10 molecular diameters, the slip solution criteria under sparse conditions are also applicable to dense gases, and the prediction accuracy improves as the Knudsen number decreases. Furthermore, the key factor affecting the fluid friction coefficient is the peak density near the wall, rather than the nominal density, fluid confinement, or channel curvature. Higher nominal density leads to higher peak density, thereby reducing slip; whereas tighter confinement results in lower peak density, increasing slip, which differs from previous findings. Additionally, fluid slip depends on microscopic roughness represented by the Smoluchowski factor. These findings lay the foundation for further understanding the molecular mechanisms of fluid slip in molecular-scale channels.