Abstract:Si is emerging as one of the most prospective anode materials for all-solid-state Li-ion batteries due to its extremely high theoretical capacity density of 4200 mAh g -1 and relatively negative potential for lithiation/delithiation. Towards its widespread use, controlling severe volume expansion/contraction during lithiation/delithiation is a challenge because it may cause cracking, fracture, and pulverization that negatively influence the cycle performance and rate capability of the cells [1]. Such mechanical event is induced by the change in the lattice structure due to the formation of Li x Si and successive increasing/decreasing of Li content x in Li x Si [2]. Bimodal atomic force microscopy (AFM) offers quantitative mapping of nanoscale mechanical property, simultaneously with surface topography imaging [3]. Our group previously applied this technique to the cross-section of a composite electrode consist of active materials, binders, conductive additives, and deposited electrolyte solution and successfully demonstrated nanomechanical mapping [4]. Here, we develop an operando bimodal AFM system to track Young’s modulus changes of electrode materials in an all-solid-state battery configuration during the lithiation and delithiation reactions in real-time. A cell in a Cu/Si/LLZT/In/Li configuration was fabricated as follows; a 3 μm-thick Si thin-film and a 100 nm-thick Cu layer were sputter-deposited on one side of Li 6.6 La 3 Zr 1.6 Ta 0.4 O 12 (LLZT) solid electrolyte, an In layer was sputter-deposited on the other side of LLZT, the Cu/Si/LLZT/In sample was milled with an Ar-ion beam to yield a flat and smooth cross-section suitable for AFM analysis, and then a 50 μm-thick Li metal foil was combined with the pre-coated In thin layer. Operando nanomechanical mapping was performed by mounting the cross-section-exposed cell in the custom-made sample holder coupled with a potentiostat for bias applications, in an Ar-filled glove box to prevent any atmospheric influences. Electrochemical lithiation and delithiation were carried out within a potential window of 0.01-1.20 V vs. Li/Li + . Electrochemical characterization indicated that the capacities of the Si electrode for the first lithiation and delithiation are 3300 and 1833 mAh g -1 , respectively. These capacities are equal to the formation of Li 3.46 Si after the first lithiation of the pristine Si and Li 1.54 Si after the successive delithiation from Li 3.46 Si. Throughout the lithiation, the averaged Young’s modulus of Si electrode decreased due to the formation of Li x Si and increase in the Li content x in Li x Si. In the initial stage of lithiation, it drastically decreased because Li x Si was formed by the lithiation of pristine Si. Then, it moderately decreased with increasing Li content x in Li x Si. Unfortunately, the Young’s modulus maps were only recorded until the formation of Li 1.54 Si because the successive delithiation was not completed possibly due to the phase transformation of crystalline Li x Si to amorphous Li x Si [5], which may cause a significant mechanical strain inside the thin film. The measured Young’s modulus values were consistent with those obtained by first principle calculation [6]. Further details are given at the presentation. References: J. Zhong, T. Wang, L. Wang, L. Peng, S. Fu, M. Zhang, J. Cao, X. Xu, J. Liang, H. Fei, X. Duan, B. Lu, Y. Wang, J. Zhu and X. Duan, Nano-Micro Letters , 14 , 50 (2022). M. T. McDowell, S. W. Lee, W. D. Nix and Y. Cui, Advanced Materials , 25 , 4966 (2013). M. Kocun, A. Labuda, W. Meinhold, I. Revenko and R. Proksch, ACS Nano , 11 , 10097 (2017). H. Sakai, Y. Taniguchi, K. Uosaki and T. Masuda, Journal of Power Sources , 413 , 29 (2019). R. Endo, T. Ohnishi, K. Takada and T. Masuda, The Journal of Physical Chemistry Letters , 13 , 7363 (2022). H. Kim, C.-Y. Chou, J. G. Ekerdt and G. S. Hwang, The Journal of Physical Chemistry C , 115 , 2514 (2011).

Anisotropic Compositional Expansion and Chemical Potential of Lithiated SiO2 Electrodes: Multiscale Mechanical Analysis

Tuning the Outward to Inward Swelling in Lithiated Silicon Nanotubes Via Surface Oxide Coating

Lithiation of SiO2 in Li-ion Batteries: in Situ Transmission Electron Microscopy Experiments and Theoretical Studies.

Stress-Dependent Chemo-Mechanical Performance of Amorphous Si Anodes for Li-Ion Batteries upon Lithiation

Deformation and failure of lithiated Si electrodes of Li-ion batteries

Heterogeneous Interface-Derived Engineered Electronic Structure of SiO with Enhanced Lithium Storage

Mechanical Properties and Chemical Reactivity of Li xSiO y Thin Films

Unraveling the Mechanism of Phase Transformation and Structural Evolution in Si Anode with Deep-Potential Molecular Dynamics

In Situ Measurement of Mechanical Property and Stress Evolution in a Composite Silicon Electrode

Atomic Insight into the Lithium Storage and Diffusion Mechanism of SiO2/Al2O3 Electrodes of Lithium Ion Batteries: ReaxFF Reactive Force Field Modeling

Systematic electrochemical characterizations of Si and SiO anodes for high-capacity Li-Ion batteries

Insights into the SiO2 Stress Effect on the Electrochemical Performance of Si anode

Molecular dynamic investigation of the structure and stress in crystalline and amorphous silicon during lithiation

The Fabrication of SiOx Single Particle Electrode and Its Electrochemo-Mechanical Study

Operando Nanomechanical Mapping of Silicon Thin Film Electrode during the First Lithiation and Delithiation Investigated By Bimodal Atomic Force Microscopy

Numerical investigation of microstructure and failure of lithiated silicon under biaxial tension

Tailoring Stress and Ion-Transport Kinetics Via a Molecular Layer Deposition-Induced Artificial Solid Electrolyte Interphase for Durable Silicon Composite Anodes

Experimental measurement of electro-chemo-mechanical properties of a composite silicon electrode in lithium ion batteries

First-principles study on the lithiation process of amorphous SiO anode for Li-ion batteries with Bayesian optimization

Unraveling the Atomic‐scale Mechanism of Phase Transformations and Structural Evolutions during (de)Lithiation in Si Anodes

Link between anisotropic electrochemistry and surface transformations at single‐crystal silicon electrodes: Implications for lithium‐ion batteries