Abstract:Metal organic frameworks (MOFs) are of significant interest for photocatalysis using visible light, but they are typically limited by the instability and high recombination ratio of photoexcited pairs. Integrating MOFs into an inorganic semiconductor is one of the most widespread methods to promote their activity. In this study, a core-shell structured MOF@TiO2 (NH2-UiO-66@TiO2) was synthesized as an efficient photocatalyst for the degradation of toluene. Pristine NH2-UiO-66 was synthesized by a hydrothermal method as the core, which was then coated with an amorphous TiO2 shell. Compared with pristine NH2-UiO-66 and other samples prepared by the direct mixing of NH2-UiO-66 and TiO2, NH2- UiO-66@TiO2 exhibited a higher degradation rate of toluene. Using NH2- UiO-66@TiO2 as a catalyst, the degradation efficiency of toluene reached 76.7% within 3 h, which is 1.48 times higher than that of NH2-UiO-66. The degradation performance was also stable in four repeated reuse experiments, and the slight deactivation was reactivated after washing with ethanol. A series of characterization methods were used to determine the physicochemical properties of NH2-UiO-66@TiO2, including X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Using the measured physicochemical properties, the photocatalytic mechanism of NH2-UiO-66@TiO2 was explored. NH2-UiO-66 is an ideal photocatalyst, with visible-light response and a huge specific surface area (914.9 m(2).g(-1)), which is favorable for the utilization of sunlight as well as the absorption of pollutants in indoor air. In addition, a new interface formed between the two components (NH2-UiO-66 and TiO2), which efficiently broaden the light absorption area and enhanced the utilization of photogenerated species. The photogenerated holes and electrons could transfer through the interlayer as soon as they were formed. It is speculated that holes would transfer to the HOMO of NH2-UiO-66, and then combine with H2O molecules to form hydroxyl radicals (center dot OH). At the same time, more electrons tended to combine with oxygen molecules in the conduction band of TiO2 rather than recombine with holes. Consequently, the recombination rate of electrons and holes decreased, while the quantity of oxygen radicals and hydroxyl radicals increased. Toluene was efficiently oxidized by these two types of radicals. Owing to the outstanding properties mentioned above, the strategy of constructing NH2-UiO-66@TiO2 is considered to be an effective approach. This work may provide new insights into the design of core-shell structured MOF@photocatalysts for the photocatalytic degradation of indoor air pollutants.

Pt Nanoparticles and NiO Nanosheets on Ni Foam for Photothermal Degradation of Toluene

Preparation of Nickel-Foam-supported Pd/NiO Monolithic Catalyst and Construction of Novel Electric Heating Reactor for Catalytic Combustion of VOCs

Regulation of Electron Density in Pt Nanoparticles Via Bimetallic Metal-Organic Frameworks for Enhancing Photothermal Catalysis of Toluene Decomposition

In Situ Growth of Well-Aligned Ni-MOF Nanosheets on Nickel Foam for Enhanced Photocatalytic Degradation of Typical Volatile Organic Compounds.

Ternary multifunctional catalysts of polymeric carbon nitride coupled with Pt-embedded transition metal oxide to enhance light-driven photothermal catalytic degradation of VOCs

Nickel foam based monolithic catalyst supporting transition metal oxides for toluene combustion: Experimental and theoretical study of interfacial synergistic oxidation and water resistance

A Facile Route for Spraying Preparation of Pt/TiO2 Monolithic Catalysts Toward VOCs Combustion

FABRICATION OF NICKEL FOAM BASED MnO2 MONOLITHIC CATALYSTS AND ITS APPLICATION IN CATALYTIC ELIMINATION OF TOLUENE

Combined effects of Pt nanoparticles and oxygen vacancies to promote photothermal catalytic degradation of toluene

Enhancing Low-Temperature Catalytic Performance for Toluene Oxidation Using In-Situ Pyrolyzed Mn-Doped MOF-74 Derived MCNOx Catalysts

Regulating oxygen vacancies and hydroxyl groups of α-MnO2 nanorods for enhancing post-plasma catalytic removal of toluene

TiO 2 -based Pd/Fe bimetallic modification for the efficient photothermal catalytic degradation of toluene: The synergistic effect of ∙O 2 – and ∙OH species

Non-thermal plasma coupled with MOF-74 derived Mn-Co-Ni-O porous composite oxide for toluene efficient degradation.

Copper-cobalt strong interaction to improve photothermocatalytic performance of cobalt-copper oxides supported on copper foam for toluene oxidation

Platinum−Copper Bimetallic Nanoparticles Supported on TiO2 as Catalysts for Photo−thermal Catalytic Toluene Combustion

Core-Shell Structured NH2-UiO-66@TiO2 Photocatalyst for the Degradation of Toluene under Visible Light Irradiation

Efficient Photothermal Catalytic Oxidation Enabled by Three-Dimensional Nanochannel Substrates

Porous " Brick-Like" NiFe2O4 Nanocrystals Loaded with Ag Species Towards Effective Degradation of Toluene

Enhanced toluene oxidation by photothermal synergetic catalysis on manganese oxide embedded with Pt single-atoms

Efficacious destruction of typical aromatic hydrocarbons over CoMn/Ni foam monolithic catalysts with boosted activity and water resistance

Single-atom Pt-CeO2/Co3O4 Catalyst with Ultra-Low Pt Loading and High Performance for Toluene Removal.