Abstract:The phase-shifted full-bridge converter is often used as an on-board DC/DC converter because of its advantages of easy control and low loss. The use of a spread spectrum modulation technique can reduce the conducted common mode electromagnetic interference. However, the spectrum expansion of periodic pulse width modulation is not strong enough and is accompanied by spectral overlapping phenomenon in the high-frequency band. In addition, the chaotic pulse width modulation generates a large number of low-frequency components and the spectrum expansion is not controllable. In this paper, discrete chaotic sequences are used to modulate the modulation frequency of the periodic function for the second time to enhance the harmonic side-band extension capability of the periodic pulse width modulation, and to solve the problem of the accumulation of the low-frequency harmonic components caused by the chaotic pulse width modulation, and the introduction of the wide-band characteristics of the chaotic sequences can alleviate the overlapping phenomenon of the spectrum in the high-frequency band. Through the whale optimization algorithm, the relevant modulation parameters affecting the periodic-chaotic pulse width modulation–modulation frequency f m and frequency extension range Δ f are optimized. Finally, a 500W phase-shifted full-bridge converter experimental prototype verifies that period-chaos pulse-width modulation has better common mode EMI attenuation characteristics when compared with period pulse-width modulation and chaotic pulse-width modulation. In addition, it verifies the accuracy of the optimized parameters. The modulation means and optimization methods proposed in this paper can be used to reduce the conducted electromagnetic interference in switching power supplies.

Optimization of periodic PWM parameters for common-mode noise suppression of on-board DC/DC converters

Model Predictive Control for the Receiving-Side DC–DC Converter of Dynamic Wireless Power Transfer

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

A Unified Design Approach of Optimal Transient Single-Phase-Shift Modulation for Nonresonant Dual-Active-Bridge Converter with Complete Transient DC-Offset Elimination

Hybrid spread spectrum modulation-based electromagnetic interference suppression of vehicle DC/DC converters

Mirror-Bridge Phase-Shift Modulation With Low Common-Mode Noise for Single-Phase CHB PFC

Impedance-Balancing-based Modulation Strategy for Common-Mode Noise Elimination of CHB Converter

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Analysis and Optimization of High-Frequency Switching Oscillation Conducted CM Current Considering Parasitic Parameters Based on a Half-Bridge Power Module

Optimization of Frequency Jittering Parameters for Conducted EMI Suppression in Switching Mode Power Supplies

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Mechanism Model and Prediction Method of Common Mode Radiation for a Nonisolated Very-High-Frequency DC–DC Converter with Cables

Uniform Distribution Pulsewidth Modulation Strategy for Three-Phase Converters to Reduce Conducted EMI and Switching Loss

Influence of PWM Current Harmonics on Electromagnetic Noise of External-Rotor In-Wheel Permanent Magnet Synchronous Motor for Electric Vehicle

Modeling and Predicting for Common Mode Noise Disturbance in Flyback Converter

An Advanced Dual-Carrier-Based Multi-Optimized PWM Strategy of Three-Level Neutral-Point-Clamped Converters for More-Electric-Aircraft Applications

Common-Mode Conducted EMI Prediction for Dual Active Bridge Converter Based on Unterminated Behavioral Model

Common mode far field radiation mechanisms and prediction of a buck converter with cables based on common mode voltage mutation method

Decoupled Dual-PWM Control for Naturally Commutated Current-Fed Dual-Active-Bridge DC/DC Converter

A Method for CM EMI Suppression on PFC Converter Using Lossless Snubber with Chaotic Spread Spectrum

Suppression of First Sideband Switching Harmonics Using DC–DC Converters With an Advanced Modulation Scheme