Abstract:Postmortem human subject (PMHS) studies are essential to brain injury research in motor vehicle safety. However, postmortem deterioration reduces the similarity between postmortem test results and in vivo response in material testing of brain tissue and in biomechanical testing of the whole head. This pilot study explores the effect of potential preservatives on brain tissue breakdown to identify promising preservatives that warrant further investigation. To identify preservatives with potential to slow postmortem degradation, samples from an initial PMHS were refrigerated at 10°C to qualitatively compare tissue breakdown from 58 to 152 h postmortem after storage in candidate solutions. On brain tissue samples from a second PMHS, compressive stiffness was measured on six samples immediately after harvest for comparison to the stiffness of 23 samples that were stored at 10°C in candidate solutions for 24 h after harvest. The candidate solutions were artificial cerebrospinal fluid (ACSF) without preservatives; ACSF with a combination of antibiotics and antifungal agents; ACSF with added sodium bicarbonate; and ACSF with both the antibiotic/antifungal combination and sodium bicarbonate. Results were analyzed using multiple linear regression of specimen stiffness on harvest lobe and storage solution to investigate potential differences in tissue stiffness. Qualitative evaluation suggested that samples stored in a solution that contained both the antibiotic/antifungal combination and sodium bicarbonate exhibited less evidence of tissue breakdown than the samples stored without preservatives or with only one of those preservatives. In compression testing, samples tested immediately after harvest were significantly stiffer than samples tested after 24 h of storage at 10°C in ACSF (difference: -0.27 N/mm, 95% confidence interval (CI): -0.50, -0.05) or ACSF with antibiotics/antifungal agents (difference: -0.32 N/mm, 95% CI: -0.59, -0.04), controlling for harvest lobe. In contrast, the stiffness of samples tested after storage in either solution containing sodium bicarbonate was not significantly different from the stiffness of samples tested at harvest. There was no significant overall difference in the mean tissue stiffness between samples from the frontal and parietal lobes, controlling for storage solution. Given the importance of PMHS studies to brain injury research, any strategy that shows promise for helping to maintain in vivo brain material properties has the potential to improve understanding of brain injury mechanisms and tolerance to head injury and warrants further investigation. These pilot study results suggest that sodium bicarbonate has the potential to reduce the deterioration of brain tissue in biomechanical testing. The results motivate further evaluation of sodium bicarbonate as a preservative for biomechanical testing using additional test subjects, more comprehensive material testing, and evaluation under a broader set of test conditions including in whole-head testing. The effect of antibiotics and antifungal agents on brain tissue stiffness was minimal but may have been limited by the cold storage conditions in this study. Further exploration of the potential for microbial agents to preserve tissue postmortem would benefit from evaluation of the effects of storage temperature.

The choice of embedding media affects image quality, tissue R2* , and susceptibility behaviors in post-mortem brain MR microscopy at 7.0T

Abstract WP292: Quantitative Susceptibility Mapping for Reliably Measuring Hematoma Volume in Magnetic Resonance Imaging

Cerebral Microbleeds: Burden Assessment by Using Quantitative Susceptibility Mapping

Postmortem 7T MRI for guided histopathology and evaluation of cerebrovascular disease

A method to image brain tissue frozen at autopsy

Comparative analysis of in situ and ex situ postmortem brain MRI: Evaluating volumetry, DTI, and relaxometry

Comparison of histological procedures and antigenicity of human post-mortem brains fixed with solutions used in gross anatomy laboratories

Investigation of Dental Alginate and Agar Impression Materials As a Brain Simulant for Ballistic Testing.

A multi-modality medical imaging head and neck phantom: Part 2. Medical imaging

Comparisons of MR and EM inferred tissue microstructure properties using a human autopsy Corpus callosum sample

Preservatives for postmortem brain tissue in biomechanical testing: A pilot study

Optimal methods for processing mineralized tissues for Fourier transform infrared microspectroscopy

An Improved Postprocessing Method to Mitigate the Macroscopic Cross-Slice B0 Field Effect on R2* Measurements in the Mouse Brain at 7T

Quantitative study on the hygroscopic expansion of spurr resin to obtain a high-resolution atlas of the mouse brain.

Investigating microstructural changes between in vivo and perfused ex vivo marmoset brains using oscillating gradient and b‐tensor encoded diffusion MRI at 9.4 T

Comparison of Transparency and Shrinkage During Clearing of Insect Brains Using Media With Tunable Refractive Index

Effects of MP2RAGE B1+ sensitivity on inter-site T1 reproducibility and hippocampal morphometry at 7T

Automated deep learning segmentation of high-resolution 7 T postmortem MRI for quantitative analysis of structure-pathology correlations in neurodegenerative diseases

Comparative study of pre- and post-mortem perfusion of fixative for the quality of neuronal tissue preparation

Differential effects of prolonged post-fixation on immunohistochemical and histochemical staining for postmortem human brains

Test-retest reproducibility of human brain multi-slice 1 H FID-MRSI data at 9.4T after optimization of lipid regularization, macromolecular model, and spline baseline stiffness