Intraoperative evaluation and measurement of a crooked nose.
S. Ínanli,M. Sarı,M. Yanik
DOI: https://doi.org/10.1097/SCS.0b013e3181a2f01f
2009-05-01
Abstract:To the Editor: C orrection of a crooked nose is still a big challenge of septorhinoplasty. Optimal correction requires correct preoperative evaluation, accurate surgical planning, and performing the surgery according to these points. Herein, we aimed to describe our intraoperative measuring technique for a crooked nose in septorhinoplasty. A deviated nose known as a crooked nose is characterized by a deviation of the external nasal pyramid in combination with a deformity of the septum. The underlying causes may be congenital and mechanical traumas in most patients. There are 4 types of deviated nose syndromes depending upon which part of the pyramid is deviated: deviated, C-shaped, reversed C-shaped, and deviated cartilaginous pyramids (S-shaped). In a deviated pyramid called an I-shaped crooked nose (linear), the bony and cartilaginous pyramid and lobule are shifted to the same side of the midline of the face (Fig. 1A, B). The nose is angulated at the nasion and rhinion. Correction of a crooked nose remains the most challenging problem for septorhinoplasty. In this paper, we describe our intraoperative evaluation and measuring technique for the correction of an I-type crooked nose. We prefer to perform the open approach and to use a general anesthesia for a crooked nose. Nasal packs soaked with 4% cocaine are placed into the nasal cavity for further anesthesia and hemostasis. The operative area is prepared and draped in the usual fashion for rhinoplastic procedures. The deviation angles of an I-type crooked nose are measured as follows: a flexible ruler that exists in a pack with a surgical marking pen (Devon Skin Marker, Kendall-LTP Tyco Healthcare Group LLP, Norwalk, CT) is used for measuring. First, the vertical midline plane from the glabella to the midline point of the supratip break area is determined (Figs. 2A and 3). Inferiorly, the distance between the lateral edge of piriform apertura where the lateral crus of lower lateral cartilage ends and the midline point of supratip break area are measured, and superiorly, the distance between the nasion and inner canthus are measured bilaterally. The difference between the right and left sides is defined and marked on the skin of nasal dorsum (Fig. 3). Submucosal injections of 1% lidocainewith epinephrine 1/100,000 are administered for less bleeding. A transcolumellar incision is performed with a No. 11 scalpel. After the skin of nasal dorsum is elevated, the septum is freed from the extrinsic forces of the deviated nasal bones and the upper and lower lateral cartilages. Septoplasty is performed, and reposition of caudal septum in the vertical midplane of the face is done. For a dorsal reduction of a bony pyramid, nasal bones and upper lateral cartilages are excised or rasped asymmetrically in millimeters according to the measurements until the previously marked point on the nose to obtain equalized nasal dorsal height (Fig. 2B). The required osteotomies (medial oblique and lateral) are performed. If needed, spreader graft application and/or alar base reduction can be done, and then, the tip plasty is performed. After the completion of the procedure, intranasal silicon and external thermal splints are applied and held in place for 1 week. Septorhinoplasty is an operation tailoring the nose. Preoperative and intraoperative plannings are very important to get good results. A surgeon has to evaluate the nose carefully to determine the pathologic condition and the required surgical process. In a crooked nose, the length of the deviated side, from piriform apertura to the midline point, of the nose is shorter than the other side. This condition requires asymmetrical resection of the bony and cartilaginous hump. In the literature, there are several preoperative and intraoperative methods to determine the appropriate resection value. Although some surgeons use preoperative computerized evaluation and perform their surgery according to that results, most surgeons determine the resection value and perform their surgery by subjective intraoperative criteria. At the end of the surgery, if both sides of the newly created pyramid are not equal, the asymmetry of the nose will persists, making the surgery unsuccessful. When the resection is done according to objective criteria, these problems will be prevented. For this reason, we measure the resection value in millimeters. To our knowledge, this millimetric resection technique has not been described in the literature. A deviated nose should be considered as an osseocartilaginous unit, and it is almost always associated with a deviated septum. If septal and bony deviations are both present, it should be corrected in a systematic fashion in the same setting. Although correction of a deviated nose can be performed by both closed and open approaches, we prefer the open approach in our cases. We generally use spreader and columellar strut grafts in our cases. This grafts give straight, stronger, and more stable structure to the nose. In some cases, alar base reduction may be added to the procedure. That can be performed unilaterally or bilaterally when indicated. In conclusion, measuring and calculating the proportions of nasal structures for preoperative evaluation are 2 of the most important issues to establish balanced and symmetrical sides at the end of