Abstract:Adhesion problems during tablet manufacturing have been observed to be dependent on many formulation and process factors including the run time on the tablet press. Consequently, problems due to sticking may only become apparent towards the end of the development process when a prolonged run on the tablet press is attempted for the first time. It would be beneficial to predict in a relative sense if a formulation or new chemical entity has the potential for adhesion problems early in the development process. It was hypothesized that favorable intermolecular interaction between the drug molecules and the punch face is the first step or criterion in the adhesion process. Therefore, the rank order of adhesion during tablet compression should follow the rank order of these energies of interaction. The adhesion phenomenon was investigated using molecular simulations and contact mode atomic force microscopy (AFM). Three model compounds were chosen from a family of "profen" compounds. Silicon nitride AFM tips were modified by coating a 20-nm iron layer on the surfaces by sputter coating. Profen flat surfaces were made by melting and recrystallization. The modified AFM probe and each profen surface were immersed in the corresponding profen saturated water during force measurements using AFM. The work of adhesion between iron and ibuprofen, ketoprofen, and flurbiprofen in vacuum were determined to be -184.1, -2469.3, -17.3 mJ. m(-2), respectively. The rank order of the work of adhesion between iron and profen compounds decreased in the order: ketoprofen > ibuprofen > flurbiprofen. The rank order of interaction between the drug molecules and the iron superlattice as predicted by molecular simulation using Cerius(2) is in agreement with the AFM measurements. It has been demonstrated that Atomic Force Microscopy is a powerful tool in studying the adhesion phenomena between organic drug compounds and metal surface. The study has provided insight into the adhesion problems occurring during tablet compression and a direction for continued study.

A quantitative model to predict the effect of magnesium stearate on punch sticking

Effect of particle size on the dispersion behavior of magnesium stearate blended with microcrystalline cellulose

To evaluate the effect of various magnesium stearate polymorphs using powder rheology and thermal analysis

Magnesium Stearate Fatty Acid Composition, Lubrication Performance and Tablet Properties

Challenges in detecting magnesium stearate distribution in tablets

Tableting model assessment of porosity and tensile strength using a continuous wet granulation route

Influence of colloidal silicon dioxide‐magnesium stearate interaction on flow and compaction behavior of an MCC-Lactose binary mixture

Selection of lubricant type and concentration for orodispersible tablets

Uncovering the Mechanism of Tenofovir Amibufenamide Fumarate Punch Sticking by Combining Direct Compression Experiment and Computational Simulation

The effect of magnesium stearate and sodium starch glycolate on powder flowability

Quantification of lubrication and particle size distribution effects on tensile strength and stiffness of tablets

Virtual screening of drug materials for pharmaceutical tablet manufacturability with reference to sticking

Reduction of Punch-Sticking Propensity of Celecoxib by Spherical Crystallization via Polymer Assisted Quasi-Emulsion Solvent Diffusion

Study of compaction tools and parameters on critical quality attributes of high drug load minitablets

Advancing tablet lubrication: A systematic comparison of feed frame lubrication and internal lubrication

Using in-line measurement and statistical analyses to predict tablet properties compressed using a Styl'One compaction simulator: A high shear wet granulation study

Modeling of adhesion in tablet compression--I. Atomic force microscopy and molecular simulation

Influence of Process Parameters on Content Uniformity of a Low Dose Active Pharmaceutical Ingredient in a Tablet Formulation According to GMP

Critical Tools in Tableting Research: Using Compaction Simulator and Quality by Design (QbD) to Evaluate Lubricants’ Effect in Direct Compressible Formulation

Determining the Drucker-Prager cap model constants using experimental, numerical and optimization for compacted Mg powders at different strain rates

Synergistic effect of magnesium stearate and fine lactose in improving aerosolization performance of fluticasone propionate in dry powder formulation