Abstract:DOI: 10.1002/adma.201306335 between adjacent cracks must be tunable. Top-down, serial approaches [ 14 ] for initiating cracks provide a simple way to control crack spacing, but even in these cases the crack width typically varies by more than an order of magnitude. Similar variability was observed when thin coatings were cracked using uniaxial strain. [ 26–28 ] Fourth, the crack should not only allow a material to deposit but also impart some degree of selectivity. Ideally, the crack should control the size, shape, and crystallographic orientation of the material that deposits. Fifth, the production of cracks in only specifi c locations of a material would be desirable. Although top-down strategies for initiating cracks one-by-one has been presented, [ 14,15 ] for many materials and applications it would be desirable to identify principles that allow the high throughput production of cracks in a spatially controlled manner. In the present work, we fabricated a composite material that is comprised of a stretchable, [ 29–31 ] polymeric substrate covered with a reactive/charged polymer onto which a monolayer of nanoparticles is adsorbed ( Figure 1 ). The nanoparticle monolayer acts like a mask and, when stretched, fragments controllably as the large, macroscopic deformation divides into the small, nanoscopic movements of adjacent particles. Because the nanoparticles are deposited as a monolayer, the process of cracking unmasks the chemically distinct substrate, thereby enabling selective surface design. Unlike in continuous materials, the cracking process is guided by the discrete nature of nanoparticles and is therefore not limited by a material’s inherent faceting and fracture characteristics. [ 14 ]

Crack formation in wet colloidal pillars

Crack densification in drying colloidal suspensions

Formation Mechanism of Radial and Circular Cracks Promoted by Delamination in Drying Silica Colloidal Deposits

Formation of circular crack pattern in deposition self-assembled by drying nanoparticle suspension.

Surface wrinkling and cracking dynamics in the drying of colloidal droplets

Interplay of Consolidation Fronts and Cracks in Drying Colloidal Coatings and Its Application in Controlling Crack Pattern Formation.

Drying-Induced Cracks in Thin Film Fabricated from Colloidal Dispersions

How to Reduce the Crack Density in Drying Colloidal Material?

Mechanical Control of Surface Adsorption by Nanoscale Cracking.

Role of evaporation rate on the particle organization and crack patterns obtained by drying a colloidal layer

Surface Roughness Induced Cracks of the Deposition Film from Drying Colloidal Suspension

Cracking to Curling Transition in Drying Colloidal Films

Polymer-Mediated Crack Suppression in Deposit of Nanoellipsoids

Suppression of cracking in drying colloidal suspensions with chain-like particles

Harnessing Colloidal Crack Formation by Flow‐Enabled Self‐Assembly

Tuning Crack Pattern by Phase Separation in the Drying of Binary Colloid–polymer Suspension

Drying crack patterns of sessile drops with tuned contact line

Manipulation Of Cracks In Three-Dimensional Colloidal Crystal Films Via Recognition Of Surface Energy Patterns: An Approach To Regulating Crack Patterns And Shaping Microcrystals

The Physics of Drying of Colloidal Dispersion: Pattern Formation and Desiccation Cracks

Crack formation and self-closing in shrinkable, granular packings

Cover Picture: Harnessing Colloidal Crack Formation by Flow‐Enabled Self‐Assembly (Angew. Chem. Int. Ed. 16/2017)