Planar and uniplanar orientation in nanocellulose films: interpretation of 2D diffraction patterns step-by-step

Xiao Han,Pan Chen,Lengwan Li,Yoshiharu Nishiyama,Xuan Yang
DOI: https://doi.org/10.1007/s10570-023-05411-5
IF: 6.123
2023-08-01
Cellulose
Abstract:X-ray diffraction (XRD) is widely used in cellulose structural characterization. The commonly used "powder" XRD assumes the sample is macroscopically isotropic. For cellulose fibrous samples, however, due to the high aspect ratio of the components, the structure is often anisotropic, and the texture affects the materials properties to a large extent. A simple setup of a point-focused X-ray beam and a two-dimensional detection of scattered X-ray is a practical tool to analyze the texture. We studied three types of cellulose nanofibril (CNF) films obtained by casting. 2,2,6,6-tetramethylpiper- idine-1-oxyl radical (TEMPO) oxidized one shows a high degree of (1–10) uniplanar orientation, whereas holocellulose CNF and enzyme-pretreated CNF showed planar orientation. In the planar orientation, the c -axis is preferentially oriented in the plane parallel to the film while within each fibril other crystallographic axis would be randomly distributed around the c -axis. Also, a clear peak can be detected at low angle corresponding to a d -spacing of 3–4 nm indicating a strong correlation perpendicular to the film at this length scale. This distance was the lowest for TEMPO-CNF and corroborates with the model of uniplanar orientation of rectangular cross-section. The numerically simulated azimuthal intensity distribution of hk0 reflections in the two types of texture agreed well with the experimental intensity distribution.
materials science, textiles,polymer science, paper & wood
What problem does this paper attempt to address?