Abstract:Several dose distribution maps were obtained using a gamma radiation detector mounted to a drone. Based on the results and experience of the experiments, the shortcomings of the system and the possibilities for further development were identified. The primary goal of the development was to create a more compact, easy-to-carry, and easy-to-install system with increased sensitivity, which was achieved by several different methods and their combinations. During the discrete measurement procedure, the aim was to decrease the detection threshold, +0.005 to +0.007 μS/h measured above the background radiation. The increase in sensitivity was based on the characteristic energy spectrum of radiative materials. We took advantage of the fact that the radiating samples do not evenly increase the amount of gamma radiation over the entire energy spectrum. During the processing of the measurement data, we performed a comparison with the background radiation in the vicinity of the energy peaks characteristic of the sample and its decay products. This provides a better signal-to-noise ratio, thus enabling a more sensitive detection procedure. An important feature of our method is that in the traditional intensity curve displayed as a function of flight time only noise is visible, therefore one cannot directly conclude the presence of the sample. However, our method is clearly able to identify the location of the searched source at a height of 8 m with a continuous flight speed of 2 m/s using a 500 μS/h activity sample (as measured at a distance of 0.1 m from the sample). The increase in sensitivity allows either a higher scanning height (approximately +1 to 2 m) or, in the case of the same aircraft at the same altitude, a larger area from one take-off. Of course, the scan height or scan speed can increase significantly if the activity of the source being sought is high. In our experiments, we used a natural uranium mineral (Autunite) with activity far below that of artificially produced isotopes. In the series of our experiments, we also covered the detection of several sources, which modeled the possibility of mapping scattered active sources. The main advantages of the system developed and presented by us over the survey procedures used in practice is that a large area can be mobilized easily, without the risk of a human operator in the field, and the survey of a large area can be carried out at a low cost. The purpose of the system is to detect the presence of the source and to localize it to such an extent that the localization can then be easily refined by manual or other ground procedures. As we do not aim for positioning accuracy by centimeter, standard GPS localization is sufficient for the measurements. During the measurements, the geographical coordinates are interpreted in the GWS'84 system. The coordinates of the latitude and longitude circles are also shown in this system in the figures presented.

Unmanned air/ground vehicle survey following a radiological dispersal event

Upscaling ground-based backpack gamma-ray spectrometry to spatial resolution of UAV-based gamma-ray spectrometry for system validation

3-D Radiation Mapping in Real-Time with the Localization and Mapping Platform LAMP from Unmanned Aerial Systems and Man-Portable Configurations

Contamination Measurements from Simultaneous Activated Potassium Bromide Radiological Dispersal Devices with a Collimated Vehicular Sensor

Spatial Deconvolution of Aerial Radiometric Survey and its application to the Fallout from a Radiological Dispersal Device

Gamma Radiation Dose Measurement Using an Energy-Selective Method with the Help of a Drone

Application of unmanned aerial vehicles in emergency radiation monitoring

Radiation Search Operations using Scene Understanding with Autonomous UAV and UGV

Safe radiation surveillance using uncrewed vehicles

UAV-based mapping of radioactive contamination of uranium mining legacies in Central Asia

Radiological Mapping of Post-Disaster Nuclear Environments Using Fixed-Wing Unmanned Aerial Systems: A Study From Chornobyl

Real-Time Gamma Radioactive Source Localization by Data Fusion of 3D-LiDAR Terrain Scan and Radiation Data from Semi-Autonomous UAV Flights

Surrogate Distributed Radiological Sources—Part II: Aerial Measurement Campaign

In-Flight Performance of the Advanced Radiation Detector for UAV Operations (ARDUO)

Design and Application of an Airborne Radioactivity Survey System Based on Unmanned Aerial Vehicle

Using an Automated Heterogeneous Robotic System for Radiation Surveys

Autonomous mapping and spectroscopic analysis of distributed radiation fields using aerial robots

Application of airborne photogrammetry for the visualisation and assessment of contamination migration arising from a Fukushima waste storage facility

A High-Performance Gamma Spectrometer for Unmanned Systems Based on Off-the-Shelf Components

Low altitude unmanned aerial vehicle for characterising remediation effectiveness following the FDNPP accident

MCNPX simulation and experimental validation of an unmanned aerial radiological system (UARS) for rapid qualitative identification of weak hotspots